BizHomart Slim42Z 40 Inches Recessed and Wall Mounted Fireplaces Instructions

BizHomart Slim42Z 40 Inches Recessed and Wall Mounted Fireplaces

Safety instructions

• Only use the appliance in accordance with the instructions in this manual! It cannot be used for any other purpose.
• Never operate the appliance when the appliance itself or the main cable show any signs of damage.
• In order to avoid overheating, do not cover the heater.
• Be responsible when handling the packing material. Warning: plastic wrapping may be lethal to children.
• Do not place the appliance next to a socket.
• Never operate the heater on a program switch, timer switch or any other appliance for automatic operation.
• The heater is only suitable for indoor use.
• Never use the heater in the bathroom, shower or near a swimming pool.
• The heater must not be located immediately below a socket-outlet
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
• Never leave small children unattended near the appliance.
• In case of malfunction, disconnect the plug immediately.
• When not in use for a considerable amount of time, unplug the appliance.
• Components should only be serviced by an approved electro technician

To switch on

Plug in the appliance into the socket. Turn on the Power Switch The control Switch Panel is on the bottom of fireplace (See pic)

Instruction for Remote Controller and Switch Panel

Control Panel / Remote Control Operation

(Control panel POWER switch must be ON to use remote control.)

WARNING: Do not move or remove the mesh trim panel, when the appliance is plugged in and operating. This will cause the remote control and touch panel to no longer function.

Remote Control Battery Information

• This remote control uses two AAA batteries (Not included).
• Instructions for battery installation are on the Remote Control battery compartment

Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature, the heater will automatically turn OFF. To reset:

1.  Unplug the power cord from the outlet.
2.  Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
3.  Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a vacuum to clean the vent areas.
4.  With the POWER switch in the OFF position, plug the power cord back into the outlet.
5.  If the problem continues, have your outlet and wiring inspected by a professional.

Care and Maintenance

Cleaning

• ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury.
• NEVER immerse in water or spray with water. Doing so could result in electric shock, fire, or personal injury.

Metal :

• Buff using a soft cloth, slightly dampened with a citrus oil-based product.
• DO NOT use brass polish or household cleaners as these products will damage the metal trim.

Glass:

• Use a good quality glass cleaner sprayed onto the cloth or towel. Dry thoroughly with a paper towel or lint-free cloth.
• NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface.

Vents:

• Use a vacuum or duster to remove dust and dirt from the heater and vent areas.

Plastic:

• Wipe gently with a slightly damp cloth and a mild solution of dish soap and warm water.
• NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface.

CAUTION: sharp edges!

1.  After installation, the power plug should be accessible.
2.  If the power cord is damaged. It must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
3.  The heater must not be located immediately below a socket.
4.  The appliance is not intended for use by young children or infirm persons. Young children should be supervised to ensure that they do not play with the appliance.
5.  Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
6.  In order to avoid overheating, do not cover the heater.

FCC CAUTION

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment, This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The equipment should be installed and operated with minimum distance 20cm between the radiator and your body

LIMITED WARRANTY

This warrants to the original purchaser that this product is free from defects in material and workmanship as of the date of purchase and that it will, under normal use and proper care, remain so for one year from the date of purchase. Missing or initially defective parts will be replaced free of charge during the period of this limited warranty. If parts are unavailable, comparable replacement of refund will be given. The original dated sales receipt is required for all warranty claims. This warranty does not cover damage which has occurred during transport from the point of purchase to the consumer’s home. This warranty does not cover glass, light bulbs, batteries, transportation, labor, or other issues not associated with the manufacture of the product. This product is for residential use only. Any and all commercial use of this product voids all warranties, and frees the manufacturer from all liability. Read and understand all assembly and operating instructions, and all safety information and warnings, before use. The following will void this warranty: Damage caused from tampering with, modifying, or altering the fireplace insert in any manner; Damage due to incorrect assembly, improper care, misuse, or abuse; Damage from being used with the wrong power source; Water damage; Damage caused from this insert being used outdoors; Damage caused from this insert being used for excessive periods of time; Damage caused by the insert being used in a commercial application; Damage from use as a primary heat source; Other misuse or abuse not specifically listed herein. This product is not intended to be used as a primary heat source. It is for supplemental heating purposes only.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>