VORTEX M0110 Mechanical Keyboard User Manual
- June 12, 2024
- VORTEX
Table of Contents
VORTEX M0110 Mechanical Keyboard
Product Information
- Product Name: 2.4Ghz/Bluetooth Keyboard
- Connectivity: 2.4Ghz and Bluetooth
Product Usage Instructions
- Switching to 2.4Ghz Mode:
- Press and hold the Fn key and Alt_L key simultaneously.
- While keeping the Fn and Alt_L keys pressed, press the number key (1, 2, or 3) corresponding to the desired device.
- The keyboard will now be in 2.4 GHz mode for the selected device.
- Switching between Paired Devices:
- In 2.4 GHz mode, use the G key to switch between paired devices.
- Press the G key once to switch to the previous paired device.
- Press the B key once to switch to the next paired device.
- Switching to Bluetooth Mode:
- Press and hold the Fn key and Alt_L key simultaneously.
- While keeping the Fn and Alt_L keys pressed, press the number key (1, 2, or 3) corresponding to the desired device.
- The keyboard will now be in Bluetooth mode for the selected device.
- Entering Pairing Mode:
- Make sure the Bluetooth switch at the bottom of the keyboard is turned on.
- Press and hold the Fn key.
- While keeping the Fn key pressed, press the Alt_L key.
- Continue holding the Fn and Alt_L keys, then press the number key (1, 2, or 3) for approximately 5-8 seconds.
- The blue light will flash 3 times to enter broadcast mode, then flash rapidly to indicate that pairing mode has been entered.
Connection
2.4Ghz / Bluetooth
- 2.4Ghz Mode (Left)
- Wired Mode (Center)
- Bluetooth Mode (Right)
Pairing Mode(Keeping press for 3 seconds) Switch between paired devices The steps to enter pairing mode are as follows:
- Turn on the Bluetooth switch located at the bottom of the keyboard.
- Press and hold the FN key, and while keeping the FN key pressed, press the Alt key.
- Continue holding the FN and Alt keys, then press the 1/2/3 key for approximately 5-8 seconds to enter pairing mode.
(During the pairing process, the blue light will flash 3 times to enter broadcast mode, then the blue light will flash rapidly to indicate that pairing mode has been entered.)
- ※ If you notice LED_A’s blue light turning on during pairing but are unable to connect, it may be due to low battery voltage.
- ◎ We recommend using wired power for pairing and switching to battery power after completion.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>