SMART Technologies G10 Wireless VR Earbuds User Manual
- June 12, 2024
- SMART Technologies
Table of Contents
G10 Wireless VR Earbuds
User Manual
Wireless VR Earbuds
Dual Connection (Bluetooth and 2. 4G)
PAIRING VIA 2. 4G DONGLE
When the dongle is plugged into the USB-C port of your VR headset or gaming console, the earbuds will automatically connect with it and be ready to use
- Use the USB-C to USB adapter if necessary
BLUETOOTH PAIRING
Open the charging case, then press and hold the button on the charging case for 3 seconds to enter Bluetooth pairing mode. Select “G10” from your device’s Bluetooth menu to connect.
- During Bluetooth pairing, the connection between the earbuds and the dongle might break temporarily. The connection of dongle will resume when the Bluetooth pairing succeeds or when you return the earbuds in the charging case, then close and open the case
DUAL CONNECTION
Dongle
The earbuds can connect with two devices (via dongle or Bluetooth) at the same
time
Bluetooth
You can only play music from one device at a time. If you have an incoming call on the Bluetooth device, the volume on the dongle connected device will be lower than that on the Bluetooth device.
CONTROLS
X2:Tap Twice
2s: Hold long for 2 second up
PLAYING WHILE CHARGING
You need a charger that supports USB PD (Power Delivery) and has a minimum output of 5V/2A or 9V/2A, otherwise this function might not work properly
- No data transmission is supported. Don’t try to link a PC to a VR headset using the USB-C cable we provided
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved
by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>