microSHIFT VerFC002001 Sword 1x 42T Crankset Instruction Manual
- June 12, 2024
- microSHIFT
Table of Contents
microSHIFT VerFC002001 Sword 1x 42T Crankset
FC002-001 www.microSHIFT.com
REMINDER
Before installing the products, please read and understand the installation procedures. Improper installation can lead to premature product failures or even injuries. If you have any questions on how to install, please contact us or consult with a professional bicycle mechanic.
Part I
The SWORD crankset is compatible with 110mm and 80mm asymmetric BCD
chainrings. You can use the same crank for a 1x or 2x setup. For a 1x setup,
use a 110 BCD narrow wide style chainring and mount it on to replace the outer
ring position.
- Torque Wrench
- 5mm Hex Bit
- 5mm Hex Wrench
- 8mm Hex Wrench
Part II
- Unthread the pinch bolts on the left crank arm a few turns with a 5mm hex wrench.
- Remove the preload bolt with an 8mm hex wrench.
- Remove the left crank arm from the spindle.
- Slide the spindle and chainrings out of the bottom bracket.
- Unthread the chainring bolts with a 5mm hex wrench. Start with the inner chainring and then the outer chainring.
- Remove the chainrings.
Part III
- Install the outer chainring. Make sure the pin on the outer side of the chainring is in line with the crank arm.
- Install the bolts and torque to 10-14Nm.
- If using a 2x crank, install the inner chainring. Make sure the raised tab on the inner ring sits in line with the crank arm.
- Install the bolts and torque to 10-14Nm. From here re-install the crankset according to the SWORD Crank Installation Manual.
www.microSHIFT.com
International service@microSHIFT.com
North America service@microSHIFT.com
Important Notice
Tools and Supplies
- Torque Wrench
- 5mm Hex Bit
- 5mm Hex Wrench
- 8mm Hex Wrench
The SWORD crankset is compatible with 110mm and 80mm asymmetric BCD chainrings. You can use the same crank for a 1x or 2x setup. For a 1x setup, use If swapping from a 2x to 1x setup, use a 110 BCD narrow wide style chainring and mount it on to replace the outer ring position.
Unthread the pinch bolts on the left crank arm a few turns with a 5mm hex wrench.
Remove the preload bolt with an 8mm hex wrench.
Remove the left crank arm from the spindle.
Slide the spindle and chainrings out of the bottom bracket.
Unthread the chainring bolts with a 5mm hex wrench. Start with the inner chainring and then the outer chainring.
Remove the chainrings.
Install the outer chainring. Make sure the pin on the outer side of the chainring is in line with the crank arm.
Install the bolts and torque to 10-14Nm.
If using a 2x crank, install the inner chainring. Make sure the raised tab on the inner ring sits in line with the crank arm.
Install the bolts and torque to 10-14Nm. From here re-install the crankset according to the SWORD Crank Installation Manual.
International
service@microSHIFT.com
North America
service@microSHIFT.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>