microSHIFT SWORD Crankset Instruction Manual

June 12, 2024
microSHIFT

microSHIFT SWORD Crankset Instruction Manual
microSHIFT SWORD Crankset

Important Notice

REMINDER

Before installing the products, please read and understand the installation procedures. Improper installation can lead to premature product failures or even injuries. If you have any questions on how to install, please contact us or consult with a professional bicycle mechanic.

This installation applies to the 1x and 2x SWORD cranksets

Tools and Supplies

  • Torque Wrench
  • 5mm Hex Bit
  • 5mm Hex Wrench
  • 8mm Hex Wrench

Tools and Supplies

Installations

  1. Apply a thin layer of grease to the bearing seats on the spindle.
    Installations

  2. Slide the crank through the drive sidev bottom bracket.
    Installations

  3. Slide the left side crank arm onto the spindle.
    Installations

  4. The crank includes a washer that goes on the preload bolt. Make sure the washer washer is on the preload bolt.
    Installations

  5. Thread the preload bolt into the spindle with your 8mm hex wrench.
    Installations

  6. The preload bolt is for removing play between the spindle and bottom bracket bearings. Lightly tighten the preload bolt until there is no play between the spindle and bottom bracket bearings and no further, about 1-3Nm.Check for play by rocking the crank arms side to side. If play exists, tighten the preload bolt further. Do not exceed 3Nm.
    Installations

  7. Tighten both crank arm pinch bolts to 12-15Nm. Alternate between bolts as you tighten them.
    Installations

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals