microSHIFT SB006-001 Sword Drop Bar Shifter Installation Guide
- June 12, 2024
- microSHIFT
Table of Contents
- Important Notice
- Tools and Supplies
- Shift Lever Attachment
- Fold the hood towards the brake lever and unthread the attachment bolt a
- Set Your Angle
- Brake Cable Installation
- Optional Reach Adjustment
- Large Shift Paddle Adjustment
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Sword Drop Bar Shifter
Installation and Adjustment
© 2023 microSHIFT | AD-II Engineering Inc.
SB006-001
www.microSHIFT.com
Important Notice
REMINDER
Before installing the products, please read and understand the installation
procedures. Improper installation can lead to premature product failures or
even injuries. If you have any questions on how to install, please contact us
or consult with a professional bicycle mechanic.
Tools and Supplies
1. Torque Wrench
2. 5mm Hex Bit
3. 5mm Hex Wrench| 4. 3mm Hex Wrench
5. 1.5mm Hex Wrench
---|---
Shift Lever Attachment
Fold the hood towards the brake lever and unthread the attachment bolt a
few turns with a 5mm hex wrench.
Set Your Height
Position each lever on the handlebar in a location that will be comfortably
accessible while riding. A good starting point is to use a straight edge that
extends from the lower edge of the drops.
Line up the bottom of the brake blade with the flat edge.
Set Your Angle
There is a small window of lateral adjustment, but generally the shifters are
designed to work best when mounted in line with flare of the handlebar.
Torque the band clamp to 8Nm and roll
the hood back into place.
Cable Installation
The SWORD drop bar shifters come with shift cables and a brake cables.
Put the shifter in the high gear/small cog position by pressing the smaller
shift lever until it stops indexing.
Roll the hood on the shifter towards
the brake lever.
Route the cable through the cable port on the lever body and out through the
top of the shifter.
Pull tight to make sure the cable head is fully seated in the shifter.
Install a housing cap on the end of
your shift housing. Slide the housing around the cable and seat the cap in the
housing stop on top of the shifter. Follow your frame manufacturer’s
guidelines for proper shift cable routing.
Brake Cable Installation
Push the brake lever toward the handlebar.
Pass the brake cable through the cable head seat inside the lever body and
make sure the head of the cable fully seats in the lever body.
Seat the cable housing in the
back side of the lever body.
Do not use a housing cap between the brake housing and housing stop.
Follow your frame and brake manufacturer’s guidelines for proper cable routing
and brake setup.
Optional Reach Adjustment
To adjust the reach on the SWORD drop bar levers, peel back the hood from the
top of the lever body. Use a 3mm hex wrench to adjust the reach.
A clockwise adjustment move the lever towards the handlebar.
And counterclockwise adjustment moves the lever away from the handlebar.
Large Shift Paddle Adjustment
The reach of the large shift lever can be adjusted between the brake lever and the small shift lever. If the brake lever reach is adjusted, it is important to also adjust the large shift paddle reach. Overadjustment of the large shift lever can cause interference with the small brake lever or small shift lever.
Move the small paddle out of the way and use a 1.5mm hex wrench to adjust the
movement of the larger shift paddle.
A clockwise adjustment moves the large paddle towards the handlebar and a
counterclockwise adjustment moves the paddle away.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>