soundmaster SCD1400 CD Boombox with FM Radio User Manual
- June 12, 2024
- soundmaster
Table of Contents
soundmaster SCD1400 CD Boombox with FM Radio
ENVIRONMENTAL PROTECTION
Do not dispose of this product with the normal household waste at the end of its life cycle. Return it to a collection point for the recycling of electrical and electronic devices. This is indicated by the symbol on the product, user manual or packaging The materials are recyclable according to their labeling. By reusing materials or other forms of recycling old devices and packaging, you are making an important contribution to protecting our environment. If necessary, remove batteries and personal data before disposal free of charge and ask your local authority about the responsible disposal point
WARNING
Risk of electric shock Do not open!
Caution: To reduce the risk of electric shock, do not remove the cover
(or back). There are no user serviceable parts inside. Refer servicing to
qualified service personnel.
This symbol indicates the presence of dangerous voltage inside the enclosure, sufficient enough to cause electric shock.
This symbol indicates the presence of important operating and maintenance
instructions for the device Used batteries are hazardous waste and NOT to be
disposed of with the household waste! As a consumer you are legally obligated
to return all batteries for environmentally responsible recycling – no matter
whether or not the batteries contain harmful substances*)
Return batteries free of charge to public collection points in your community
or shops selling batteries of the respective kind.
Only return fully discharged batteries *) marked Cd = cadmium, Hg = mercury, Pb = lead
- Only use mercury and cadmium-free batteries.
- Used batteries are hazardous waste and NOT to be disposed of with the household waste!!!
- Keep batteries away from children. Children might swallow batteries.
- Contact a physician immediately if a battery was swallowed.
- Check your batteries regularly to avoid battery leakage.
- Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
- CAUTION: Danger of explosion if battery is incorrectly replaced
- Replace only with the same or equivalent type
CAUTION: INVISIBLE LASER RADIATION WHEN OPENING THE COVER OR PRESSING THE SAFETY INTERLOCK. AVOID EXPOSURE TO THE LASER BEAM.
- The device is equipped with a “Class 1 Laser”. Avoid exposure to the laser beam as this could cause eye injuries.
- Use the device in dry indoor environments only.
Safety, Environmental and Setup Instructions
- Protect the device from humidity.
- This apparatus is for moderate climates areas use, not suitable for use in tropical climates countries.
- No objects filled with liquids, such as vases, shall be placed on the apparatus.
- The mains plug or an appliance coupler is used as the disconnect device, the disconnect devices shallremain readily operable.
- Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the specifications on the rating plate.
- Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
- A damaged mains cable or plug must immediately be replaced by an authorized service center.
- In case of lightning, immediately disconnect the device from the mains supply.
- Children should be supervised by parents when using the device.
- Clean the device with a dry cloth only.
- Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!
- Do not expose the device to direct sunlight or other heat sources.
- Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
- Do not cover the ventilation openings!
- Install the device at a safe and vibration-free location.
- Install the device as far away as possible from computers and microwave units; otherwise radio reception may be disturbed.
- Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized service/ customer center.
- No naked flame sources, such as lighted candles, should be placed on the unit.
- When you are necessary to ship the unit store it in its original package. Save the package for this purpose.
- In case of malfunction due to electrostatic discharge or fast transient (burst), remove and reconnect the power supply.
- If the unit is not using for a long period of time, disconnect it from the power supply by unplugging the power plug. This is to avoid the risk of fire.
LOCATION OF CONTROLS
- VOLUME KNOB
- FUNCTION SWITCH
- HANDLE
- TUNING KNOB
- CD DOOR
- SPEAKER
- POWER INDICATOR
- LED DISPLAY / FUNCTION INDICATOR
- PROGRAM INDICATOR
- STOP
- SKIP-
- PLAY/PAUSE
- SKIP+
- REPEAT
- PROGRAM
- ANTENNA
- AUX IN JACK (3.5MM)
- BATTERY COMPARTMENT
- AC SOCKET
AC OPERATION
Before operation, please make sure that the VOLTAGE mentioned on the unit is same as the voltage of your local area. Unravel the AC power cord, insert one end into the AC socket on the set, and the other end into a standard AC outlet.
Attention
- Do not plug or unplug the power cable while you have wet hands.
- When planning not to use this unit for a long time, disconnect the power cable from the wall outlet.
- When disconnecting the power cord from the wall outlet, do not pull on the cord in order to avoid shock risks caused by damaged cable.
BATTERY OPERATION
Disconnect the AC cord completely. Open the battery compartment door and insert 6 pieces LR14 / “C” size batteries into the battery compartment with battery polarity as shown inside the battery compartment.
RADIO
- Set the FUNCTION switch to FM position.
- Rotate the TUNING control to tune to your desired radio station.
- Adjust the sound level by rotating the VOLUME control.
- To turn off the radio, set the FUNCTION switch to OFF position.
For best reception, fully extend the FM Antenna to receive FM stations.
CD MODE
- Set the FUNCTION switch to the CD position.
- Insert the CD disc in the CD compartment and close the CD door, the unit will start reading the disc, the LED display will show the total number of tracks of the entire disc after reading.
- To start playing the CD, press the button and display LED indicator light on.
- To pause CD playback, press the button again and display LED indicator is blinking.
- Adjust the VOLUME control to the desired volume level.
- Press or button to skip to next or previous tracks.
- Hold or button to search the point of sound quickly
- To stop playing the CD, press the STOP button.
Repeat Mode
Repeat 1: Press the REP button once, the repeat LED indicator will light
and flash continuously. This single track will be repeated.
Repeat All: Press the REP button twice, the repeat LED indicator will
stay lighted. The whole disc will be played continuously.
To Cancel Repeat Function: Press the REP button until the lighted repeat
LED indicator turned off.
Programming the CD Player
- The programming of the CD player should be done during STOP mode.
- Press the PROG button, the LED display will show ‘ 01 ‘ and flash continuously.
- Press the or buttons to select the desired track.
- Press the PROG button again to store this track in memory, the LED will show ‘ 02 ‘ and flash continuously.
- Repeat steps from 2 to 3 to store more tracks in memory. You can store up to 20 tracks in the memory.
- Press the button to play the disc in the programmed order.
- To stop playing, press the STOP button.
- To cancel the programming list, press the STOP button and open the CD door or set the FUNCTION switch to OFF position.
AUX
- Switch the unit into CD mode and connect the AUX In cable (not included) to AUX In jack; The unit is switching in AUX mode.
- Start playback and change the volume level on this item or External Music Device separately
Important Note
Automatic standby switching To comply with the ERP2 directive, the unit automatically switches to standby after approximately 15 minutes without a signal. To switch the unit on again, put the FUNCTION switch in OFF and again in ON position
The current instruction manual can be downloaded from
www.soundmaster.de
Technical changes and misprints reserved. Copyright by Woerlein GmbH, 90556
Cadolzburg, www.soundmaster.de Duplication only with the permission of
Woerlein GmbH
Contact
IMPORTER
- Woerlein GmbH
- Gewerbestraße 12 D 90556 Cadolzburg, Germany
- Tel: +49 9103 71 67 0
- Fax: +49 9103 71 67 12
- E-Mail: info@soundmaster.de
- Internet: www.soundmaster.de
Hereby, Wörlein GmbH declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. A copy of the declaration of conformity can be obtained from the above address.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>