ECOLITE 2000281C Ledstripe Crait Rgb Med Transformator 2M Instruction Manual
- June 4, 2024
- ecolite
Table of Contents
2000281C Ledstripe Crait Rgb Med Transformator 2M
Instruction Manual
2000281C Ledstripe Crait Rgb Med Transformator 2M
CRAIT
Art. nr: 595174, 595175
SAFE INSTALLATION
WARNING:
For your protection and safety, carefully read and understand the information
provided in this manual completely before attempting to assemble, install or
operate this product.
- Lay out the LED strip in the desired location and ensure the area is clean and dry. Do not cut the strips as it will impair the IP rating
- Before use, please check that there is no damage to the product.
- Make sure that the strip is free from all packing before use
- Make sure that the LED strip’s voltage corresponds with that of the drive unit and ensure that the polarity is correct.
- When two or more LED strips are connected, make sure the maximum recommended length is not exceeded.
- Make sure the power is switched off during installation and that the LED strips do not overlap to avoid overheating.
- It is important that the LED luminaire’s maximum specified ambient temperature is taken into consideration to guarantee its life span, if this is exceeded, the life span can be shortened.
- Use the recommended/approved assembly fittings to ensure the lifespan of the LED strip.
- Do not try to modify the product in any kind of way.
- The LED chip should not be exposed to direct sunlight.
- Do not bend or twist the strips more than 90°.
- Do not operate while the LED strip is coiled.
- This is an electrical product, not a toy! To avoid the risk of injury or electric shock, this product should not be played with or placed where small children can reach it.
- Do not install the fixture near flammable liquids.
- Do not turn on the product before it is completely unpacked.
Installation:
Elektro Elco AB, Tallvägen 5
SE-564 35 Bankeryd, Sweden
www.ecolite.se
UM034
201804
References
Read User Manual Online (PDF format)
Loading......