KIRA LED Stripe Ecolite Installation Guide
- June 3, 2024
- ecolite
Table of Contents
KIRA LED Stripe Ecolite
DIMENSION
WARNING:
For your protection and safety, carefully read and understand the information
provided in this manual completely before attempting to assemble, install or
operate this product.
-
Lay out the LED strip in the desired location and ensure the area is clean and dry. Do not cut the strips as it will impair the IP rating.
-
Before use, please check that there is no damage to the product.
-
Make sure that the strip is free from all packing before use
-
Make sure that the LED strip’s voltage corresponds with that of the drive unit and ensure that the polarity is correct.
-
When two or more LED strips are connected, make sure the maximum recommended length is not exceeded.
-
Make sure the power is switched off during installation and that the LED strips do not overlap to avoid overheating.
-
It is important that the LED luminaire’s maximum specified ambient temperature is taken into consideration to guarantee
its life span, if this is exceeded, the life span can be shortened. -
Use the recommended/approved assembly fittings to ensure the lifespan of the LED strip.
-
Do not try to modify the product in any kind of way.
-
The LED chip should not be exposed to direct sunlight.
-
Do not bend or twist the strips more than 90°.
-
Do not operate while the LED-strip is coiled.
-
This is an electrical product, not a toy! To avoid the risk of injury or electric shock, this product should not be played with or placed where small children can reach it.
-
Do not install the fixture near flammable liquids.
-
Do not turn on the product before it is completely unpacked.
Installation
Elektro Elco AB, Tallvägen 5, SE-564 35 Bankeryd, Sweden | www.ecolite.se | UM034 | 201804
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>