YEELIGHT Sunset Lamp 11 version R2 User Manual
- June 12, 2024
- Yeelight
Table of Contents
Yeelight Sunset Lamp User Manual
INTRODUCTION
Please read this manual carefully before use and keep it properly.
Note: The illustrations for the product, accessories and user interface
in the manual are all schematic diagrams for reference only. Due to updates
and upgrades of the product, the actual product may be slightly different from
that shown in the schematic diagram, and the actual product shall govern.
Press the bution to turn on power and switch between modes.
In the initial OFF mode, press once to reach the maximum light level, press
for the second time to reach the minimum light level, and press for the third
time to turn off the light (normally closed mode). These operations can be
performed in cycles.
Mount the lamp
Method 2
There is a nut (1/4 inch nut) at the botiom of the sunset light, which can be
used with most tripods on the market (to be purchased separately).
PLEASE READ THIS MANUAL CAREFULLY BEFORE USE.
Manufacturer: QingdaoYeelink InformationTechnology Co., Ltd
Address: 10F-B4, Building B, Qingdao International Innovation Park, No.1
KeyuanWeiyi Road, Laoshan District, Qingdao City, Shandong Province, P.R.China
Website: www.yeelight.com
Customer Service Email:support@yeelight.com
SPECIFICATIONS
Model: YLFWD-0006
Rated voltage: 5V ***1A
Rated power: 3W
Operating temperature: -10 to 40 °C
Operating humidity: 0%-85%RH
Dimensions: 82mm82mm*95mm
Net weight: About 300g
WARNING
-
Before use, please verify the voltage to use conforms to the operating voltage of this product.
Using an improper voltage may cause damages to the product and safety problems. -
If the lamp does not turn on the first time you use it, please charge it.
-
Install and use the product in a place that is far away from heat sources, such as heating vents and conditioner vents, and that is not exposed to direct sunlight.
-
Make sure that the sensing area of this product is not covered by other objects. When cleaning the surface of the product, wipe it with a soti cotion cloth without using any corrosive solvents.
-
This product is not tested for waterproofing. Do not spray water on it or soak it in water to a void any safety risks.
-
Do not use this product as a children’s toy to avoid accidents.
-
For indoor use only.
-
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person
Class Ⅲ Luminaire
EU Deslaration of Conformity
We QINGDAO YEELINK INFORMATION TECHNOLOGY CO., LTD., Hereby, declares that
this equipment is in compliance with the applicable Directives and European
Norms, and amendments.
WEEE Disposal and Recycling
All products bearing this symbol are waste electrical andelectronic equipment
(WEEE as in directive 2012/19/EU) which should not be mixed with unsorted
household waste.Instead, you should protect human health and the environment
by handing over your waste equipment to a designated collection point for the
recycling of waste electrical and electronic equipment, appointed by the
government or local authorities. Correct disposal and recycling will help
prevent potential negative consequences to the environment and human health.
Please contact the installer or local authorities for more information about
the location as well as terms and conditions of such collectionpoints.
Supplier’s Declaration of Conformity (SDoC)
Equipment approved using SDoC is required to be tested, however, it is not
necessary to use an FCC-recognized accredited testing laboratory. However, as
minimum the testing laboratory used is required to maintain a record of the
measurement facilities as specified in Section 2.948 and a record of the
measurements made as specified in Section 2.938
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>