HTC TWS9 True Wireless Earbuds User Guide
- June 4, 2024
- HTC
Table of Contents
HTC True Wireless Earbuds 9
Quick Start Guide
Model HTC TWS9
What’s in the box
- 2 Earbuds
- Charging case
- Quick Start Guide
- USB Type-C cable
- 2 pairs of rubber tips (large and small)
- Warranty card
Important:
Before use, make sure to tear off the protective film.
Things to keep in mind with HTC True Wireless Earbuds 9
- HTC True Wireless Earbuds 9 should not be used in extreme temperatures.
- Before using the charging case for the first time, make sure to charge it using a 5-volt charger
Pairing HTC True Wireless Earbuds 9 with your phone
The earbuds will turn on automatically when taken out of the charging case.
Here’s how to pair them with your phone:
-
On your phone, go to Settings, turn Bluetooth on, and then pair with “HTC TWS9”. Check your phone user guide to find out how to access Bluetooth settings.
Note:
• If you don’t see the earbuds shown in the list, you can reset them by quickly tapping 5 times on either earbud. The LED on the earbuds will flash red several times. Put the earbuds back in the charging case to complete the factory reset.
• If pairing fails, put the earbuds back in the case and try again.
• When the earbuds are on and haven’t connected to any mobile device, they will continue to search for devices. The earbuds will turn off automatically after 5 minutes. -
Once paired, the earbuds will automatically connect to your mobile device when taken out of the charging case.
-
When you’re not using the earbuds, place them in the charging case to charge them. Recharge the case with a 5V charger periodically.
Controls
Power on/off| Earbuds will turn on when removed from the charging case and
turn off when they’re put back in the case.
---|---
Play next| Double-tap the right earbud.
Play previous| Double-tap the left earbud.
Play / Pause| Tap either earbud.
Game mode on/off| Tap and hold either earbud for 2 seconds.
Answer call / End call| Tap either earbud.
Decline call| Tap and hold either earbud for 2 seconds.
Assistant| Triple-tap either earbud.
LED notifications
Charging case LED| • Flashing blue: Connected to power and charging
• Blue: Case is fully charged
• Flashing red: Low battery warning
• Red: Charging the earbuds
• Off： Earbuds are fully charged
---|---
Earbud LED| • Red: Charging
• Flashing blue: Pairing
• Blue: Game mode on
• Off: Fully charged or paired with a mobile device
Technical specifications
| Bluetooth version | 5.3 |
|---|---|
| Sweat and water resistant | IPX4 |
| Bluetooth range | ≦ 10 m |
| Playtime | Approx. 6.5 hours (Volume level 50%) |
| Talk time | Approx. 3.5 hours (Volume level 50%) |
| Standby time | Up to 70 hours |
| Earbud charges (when the case is fully charged) | Around 2 charges |
| Earbud battery capacity | 40 mAh |
| Charging case battery capacity | 300 mAh |
| Charging case input voltage | 5V |
| Charging interface | Type-C |
| Charging case power input rating | 5V / 300 mA |
| Net weight (single earbud) | 5g |
| Net weight (both earbuds with case) | 44g |
Checking product authenticity
1. Scan the QR code on the package with your phone.| 2. Scratch off the
coating. You’ll then see a code.
3. On your phone, enter the last four digits of the code.| 4. If the code is
authentic, the Search the results screen will show that you have a genuine
product code.
Warning: If you see the above screen, beware of counterfeiting.
FCC Warning
FCC ID: 2AVFE-HTCTWS9
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference. (2) This device must accept any interference received, including
interference that may cause undesired operation.
Note:
• This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
• Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF exposure statement
This equipment complies with the FCC radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Legal notice
Trademarks and permissions:
HTC and the HTC logo are trademarks of HTC Corporation and are used under
license by Water World International Industrial Limited.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc.
Copyright © 2022 Water World International Industrial Limited. All rights
reserved.
THIS DOCUMENT IS FOR INFORMATION PURPOSES ONLY AND DOES
NOT CONSTITUTE ANY KIND OF WARRANTIES.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>