SKYLIGHT HYPERSPOT S Lamps Direct Almost Instruction Manual

SKYLIGHT HYPERSPOT S Lamps Direct Almost

Product Information

• Model Dimension:
  • HYPERSPOT S: 349x260mm
  • HYPERSPOT M: 625x260mm
  • HYPERSPOT L: 902x260mm
• Power Rating:
  • HYPERSPOT S: 48 W
  • HYPERSPOT M: 72 W
  • HYPERSPOT L: 96 W
• Luminous Flux:
  • HYPERSPOT S: 4500 lm
  • HYPERSPOT M: 6750 lm
  • HYPERSPOT L: 9000 lm
• Beam Angle: 60 degrees
• Color Temperature: Adjustable from 5000-15000 K
• Voltage Rating: 12 V DC
• Current Rating:
  • HYPERSPOT S: 4 A
  • HYPERSPOT M: 6 A
  • HYPERSPOT L: 8 A
• Cable Length: 1.5 m*

Product Usage Instructions

1. Hang the HYPERSPOT lamp at least 15 cm above the water surface using the provided hanging suspension kit.
2. Clean the PMMA glass cover of the LED module with a soft cloth and no chemicals. Do not clean the lamp when it is turned on.
3. Connect all cables as shown in the provided diagram before connecting to the mains network.
4. If using the AQCT-2 or AQCT-3 controller, connect it in position 1/2/3 instead of the cable splitter.
5. Use only compatible power supplies with identical parameters listed below:

Compatible Dimmer-Controller: AQCT-2 or AQCT-3

CAUTION! Using an inappropriate power supply can result in damage to the lamp or power supply itself.
If any repairs are required or for lamp service, contact your supplier. The LED module in this lamp should not be replaced by unqualified personnel. LED modules can be obtained from your supplier. Dispose of the product at designated collection points and not as unsorted municipal waste.

INTRODUCTION

The SKYLIGHT HYPERSPOT series lamps are manufactured in different versions suited for different aquarium dimensions. They come equipped with a hanging suspension kit. Electric ratings of different versions are presented in Table

Table 1.a. HYPERSPOT – specification.

SAFETY INSTRUCTIONS

• The product is only intended to be used for aquarium lighting, indoors and at room temperature.Follow the installation instructions. Keep children and pets other than your aquarium animals away from the lamp.
• Do not use a mechanically damaged device, do not modify the construction.
• Do not switch on the device if any cable(including the power supply)is damaged.
• Only intended to be used with one of the dedicated power supplies*). Do not exceed electrical ratings!
• Do not look directly into the light source.
• Turn the lamp on only after it is installed over aquarium.
• Do not cover the lamp with rugs or blankets.

INSTALLATION INSTRUCTIONS

Hyperspot lamps should be hanged minimum 15 cm above the water surface. Elements of the hanging suspension kit are shown in Fig ❶.

• Lenght: 1,5 m
• Weigth: 120 g
• Maximum long term load: 18kg/175N
• Maximum short-term load: 90kg/885N
• Material: Stainless stee
• Position of the mounting holes for the hanging suspension kit. Fig. ❷

GENERAL INSTRUCTIONS AND HANDLING

• The PMMA glass cover of the LED module should be cleaned using a soft cloth and with no chemicals. Do not clean the lamp when it is turned on.
• All cables should be connected as shown in Fig. ❸ before the setup is connected to mains network.
• If the AQCT-2 or AQCT-3** controller is used it should be connected in position 1/2/3 (instead of the cable splitter).

  * List of compatible power adapters:

or other power supplies with identical parameters.

  * Compatible dimmer-controller: AQCT-2 or AQCT-3  

CAUTION!:
Using an inappropriate power supply will result in damage to the lamp or power supply itself!

REPAIRS AND UTILIZATION

Do not try to repair a damaged lamp. For information about lamp service contact your supplier. The LED module in this lamp is not intended to be replaced by unqualified personnel. LED modules are available from your supplier, contact them for details. Product cannot be disposed of as unsorted municipal waste. According to the directive 2012/19/UE, the device should be disposed of at designated collection points.

WARRANTY

• SKYLIGHT warrants this product to be free of defects in material and workmanship under normal use for 2 years from the date of purchase. The obligation of this warranty is limited to the repair or replacement of defected elements.
• No claim shall be allowed under this warranty if, in the opinion of SKYLIGHT, this product has been subject to accident or improper usage, including, but not limited to: damage, improper storage, accidental dropping etc.
• Please send the damaged device to your supplier including power supply and cables, the completed warranty card and receipt. The serial number on the device has to be the same as in the warranty card. The obligation of this warranty is limited to the device bought, and no claim shall be allowed under this warranty due to damage or loss of any other objects.

WARRANTY CARD

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>