SEVERIN SM 3586 Induction-Type Milk Frother Instruction Manual

: June 12, 2024
: SEVERIN

SM 3586 Induction-Type Milk Frother

ART.-NO. SM 3586

Instructions for use

Induction-type milk frother

Dear Customer,
Before using the appliance, read the following instructions
carefully and keep this manual for future reference. The
appliance must only be used by persons familiar with these
instructions.

Connection to the mains supply
The appliance should only be connected to an earthed
socket installed in accordance with the regulations. Make
sure that the supply voltage corresponds with the voltage
marked on the rating label of the appliance. This product
complies with all binding CE labelling directives.

Familiarization

1. Lid with insert
2. Milk container with handle
3. Stirring tool – smooth
4. Stirring tool cover
5. Stirring tool – serrated
6. Power cord with plug
7. Wind-up cable storage (on underside)
8. Rating label (on underside)
9. On/Off button
10. Easy-select rotary control
11. Base
12. Light ring

Important safety instructions

In order to avoid hazards, repairs
to this electrical appliance or its
power cord must be carried out by
our customer service. If repairs are
needed, please contact our customer
service department by phone or email
(see appendix).
Before cleaning the appliance,
ensure it is disconnected from the
power supply and has cooled down
completely.
Detailed information on cleaning can
be found in the section Cleaning and
care.
Do not immerse the base in liquids,
and do not clean it under running
tap water.
Caution: The electrical connection in
the base must be protected at all times
against possible spillage of liquids.
The milk frother must only be used on
its designated base.
Caution: Any misuse can cause
severe personal injury.
Always use the milk container handle,
as the surface may be hot during and
after operation.
The appliance is not intended to be
operated by means of an external
timer or separate remote-control
system.
This appliance is intended for
domestic or similar applications, such
as the
– staff kitchens in shops, offices and
other similar working environments,
– agricultural working environments,
– by customers in hotels, motels etc.
and similar accommodation,
– in bed-and breakfast type
environments.
This appliance may be used by
children (at least 8 years of age) and
by persons with reduced physical,
sensory or mental capabilities, or
lacking experience and knowledge,
provided they have been given
supervision or instruction concerning
the use of the appliance and fully
understand all dangers and safety
precautions involved.
Children must not be permitted to play
with the appliance.
Children must not be permitted to
carry out any cleaning or maintenance work on the appliance unless they
are supervised and at least 8 years of age.
The appliance and its power cord must
be kept well away from children under
8 at all times.
Caution: Keep any packaging materials well away
from children – such materials are a potential source of
danger, e.g. of suffocation.
Every time the appliance is used, the main body
including the power cord as well as any attachment fitted
should be checked thoroughly for any defects. Should
the appliance, for instance, have been dropped onto
a hard surface, or if excessive force has been used to
pull the power cord, it must no longer be used: even
invisible damage may have adverse effects on the
operational safety of the appliance.
This appliance is solely designed for heating up and
frothing milk, hot chocolate and cocoa. Do not put any
other type of liquid or solid food in the container.
Do not leave the milk frother unattended while in use.
Always observe the min and max level marks inside the
milk container for each application.
The protrusion in the bottom of the container (min.
level mark) must be covered by the milk. If there is not
enough milk, the appliance may overheat.
Overfilling the container may cause danger if frothing
milk is forced out.
Caution: The lid must always be fitted during operation.
Do not cover the ventilation slots at the rear of the
appliance.
The appliance may only be used with the original
accessory parts provided by the manufacturer.
The appliance must always be set on a firm, level
surface.
Do not allow the appliance or its power cord to come
into contact with open flames or any hot surfaces such
as hot-plates.
Do not allow the power cord to hang free; the cord must
be kept well away from hot parts of the appliance.
Always remove the plug from the wall socket
– in case of any malfunction,
– after use,
– before cleaning the appliance.
When removing the plug from the wall socket, never pull
on the power cord; always grip the plug itself.
No responsibility is accepted if damage results from
improper use, or if these instructions are not complied
with.

Before using for the first time

Remove any remaining packaging materials and
promotional stickers, and check that all components are
present.
Before the appliance is used for the first time, or after
extended periods of non-use, it should be thoroughly
cleaned as described in the section Cleaning and care.

Wind-up power cord storage

There is a power-cord storage compartment in the base.
Unwind the cord to the required length before use.
Wind up the power cord again after use.

Operation Lid

T he lid must always be fitted during operation.
To add ingredients during operation, turn and then take
off the lid insert.
For storage, the smooth stirring tool can be fitted to the
lid insert.

Light ring

Red
A function with heating is selected.
Blue
A function without heating is selected.

Steady light
Preparation is in progress.
Flashing red or blue
The unit is waiting for an input, preparation is complete, or
an error has occurred (see Trouble shooting at the end of the instructions).

Selecting the stirring tool
The following stirring tools are available:

? smooth

? serrated

? serrated with cover

Beverage

|

Function

|

Stirring tool

---|---|---

Milk froth

|

Frothing

|

Hot milk

|

Heating

|

Hot chocolate/ cocoa

|

Heating

|

+

Fill amounts

MIN minimum quantity 120 ml – the protrusion must be covered
MAX Frothing maximum quantity of milk 350 ml (lower max mark)
MAX Stirring and heating maximum quantity 700 ml (upper max mark)

Preparing the appliance

∙ Remove the lid from the milk container.

∙ Fit the selected stirring tool in the milk container and push it down: ensure it is seated on the lower part of the protrusion.

∙ Put the required amount of milk into the container.

∙ Place the lid on the container.

∙ Insert the plug into the wall socket.

∙ Place the milk container onto the base.

Preparation

∙ Turn the rotary control to turn the appliance on and select the required function:

? cold frothing 45°-65°

? warm frothing or heating milk 45 to 65 °C

? hot chocolate / cocoa +

∙ Press to start the preparation.

∙ Note:

If the appliance is not in stand-by mode, the button must be pressed twice.

∙ The programme starts.

∙ To prepare cocoa and hot chocolate, fill in the desired amount of cocoa powder or chocolate (see Preparation instructions).

∙ Once processing is complete, the heating and stirring process stops automatically.

∙ You can now remove the milk container from the base. ∙ Pour out the prepared food, or use a suitable spoon to take off the milk froth. Do not leave any residual amounts in the container.

∙ Detach the power cord from the wall socket after use. ∙ Always allow the appliance to cool down first, and then clean it, before starting a new cycle.

Preparation instructions

Milk froth:

∙ We recommend using milk with a high protein content. For best results, the milk should be taken from the refrigerator immediately before frothing.

∙ To achieve a thicker froth, go through a cold-frothing cycle first, followed by a hot-frothing cycle.

Hot chocolate / cocoa:

∙ To prepare drinking chocolate from milk and chocolate or cocoa.

∙ Grate the chocolate finely before preparation. ∙ Alternatively, break down the chocolate to pieces of 5 x 4 cm minimum (but not any smaller). Caution: Do not fill in melted chocolate!

∙ Fill in the chocolate / cocoa only after the programme has started, when the milk is already being stirred. Otherwise, the stirring tool could jam.

∙ We recommend using the following amounts of chocolate:

200 ml milk ? approx. 15-20 g

350 ml milk ? approx. 30-35 g

Interrupting a cycle

The heating or stirring process may be stopped by pressing at any time.

Automatic switch-off

The appliance switches off automatically two minutes after non-use.

Cleaning and care

Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down completely. ∙ To avoid the risk of electric shock, do not clean the base or the power cord with water and do not immerse them. ∙ The base can be cleaned with a soft, damp cloth and some detergent.
The milk container, stirring tools and lid should be cleaned after each cycle of use with hot water and a little detergent, or in the dishwasher. If necessary, the serrated stirring tool may be taken off and cleaned with a suitable brush.
Wipe all parts thoroughly dry.
Do not use abrasives or harsh cleaning solutions.

Disposal

Devices marked with this symbol must be disposed of separately from your household waste, as they contain valuable materials which can be recycled. Proper disposal protects the environment and human health. Your local authority or retailer can provide information on the matter.

Trouble shooting

Problem

|

Cause

|

Remedy

---|---|---

Milk is not frothing / The light ring flashes red and blue

|

Missing stirring tool

|

Fit stirring tool

|

The motor jams

|

Detach the milk container, remove the blockage, re-start the appliance

Light ring is flashing

|

Milk container was removed during operation

|

Fit the milk container and re-start the appliance

Appliance doesn’t start

|

The unit was not in stand-by mode when was pressed

|

Press again

Should you be unable to solve the problem using the table, please contact our Customer Service. The contact data can be found in the appendix to this manual.

SEVERIN Elektrogeräte GmbH
Röhre 27
D-59846 Sundern
Tel +49 2933 982-0
Fax +49 2933 982-1333
information@severin.de

Technische Änderungen vorbehalten. / Model specifications are subject to change.
I/M No.: 10097.0000 08/22

www.severin.com