THE HOME DEPOT HDDTYNKS0008 Farmhouse Ceramic Sink Instruction Manual

HDDTYNKS0008 Farmhouse Ceramic Sink
Instruction Manual

INSTALLATION INSTRUCTIONS

Recommended Tools:

Pre-Install:

Measure the exact dimensions of your sink. Measure the width from the front top left corner to the front top right corner to get the full width of the sink. Measure the depth from the front center to the back center. Make sure these 2 measurements are larger than the countertop cut measurements.
IMPORTANT We recommend consulting a professional if you are unfamiliar with installing kitchen fixtures and plumbing.

Step 1:
Model No.DLO1-760 Mark 29in width to cut out on the bottom of the countertop IMPORTANT Due to the nature of ceramics, each sink dimensions may vary slightly. Make sure your physical sink width is wider than the cut countertop width of 29in.

Step 2:
Mark 151/8in depth (front to back) to cut out on the bottom of the countertop. Step 3:
For laminate countertops only, drill pilot holes in the two back corners of the countertop cut area, then use a saw to cut the countertop. For other countertop materials refer to your fabricat or manufacturer’s suggested cutting instructions. Step 4:
Apply silicone to all edges that sink touches the countertop. IMPORTANT To prevent water leaking into the countertop, sink must be installed with all three cut edges sealed with silicone. Silicone is not included.

Step 5:
With 2 people using caution, carefully top mount the sink into precut countertop. IMPORTANT Take care when handling ceramic sinks as they are very heavy

Step 6:
Apply additional silicone to seal up all edges around the sink. INSTALLATION INSTRUCTIONS

For Use With KB’s Deck MQU”t Twin Handles Kitchen Faucet with Sprayer
Need Tools:

BEFORE BEGINNING INSTALLATION

1. Flush plumbing lines to clear any debris.
2. Shut off both supply lines after flushing.

1. Shut off hot and cold water supply under sink. Plug sink drain with cloth to avoid losing small parts. Remove old faucet

2. Set the faucet in place, insert the inlet shanks through the sink holes, and press down. Assemble the washers and locknuts on the inlet shanks, and then tighten the nuts by hand.
   

3. Install spout onto faucet body and tighten it

4. Apply Teflon tape to inlet shanks and connect supply lines.
   

5. For model is with spray head and hose, place the spray guide through the fourth hole in the sink, screw the locknut onto the shank and tighten firmly.

6. Apply Teflon tape to threads on faucet shank and shut off valves, connect water supply line.
   

7. Insert hose through guide and apply Teflon tape to sprayer shank. Attach hose to sprayer shank.

8. Turn on water supply valves and check for leaks, especially all supply line connections.
   

9. Remove aerator and turn on both hot and cold valves, let water run for at least one minute, this will clear any debris left in the line, reinstall aerator.

10. Remove spray head by unscrewing the sprayer in a counter clockwise direction, turn on both hot and cold valves and let water run for at least one minute, this will clear any debris left in the line.

Warning!!!

• Do not over-tighten nut during installation.
• Over-tighten may crack the valve and cause severe leak.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>