PHILIPS SRP4050 Universal Remote For Hisense TVs User Guide
- June 4, 2024
- Philips
Table of Contents
Replacement
Remote SRP4050 Replacement Remote for Hisense ® TVs
Quick start guide
.
Insert batteries (not included)
Set up by code selection
- Switch on your TV.
- Press and hold 1 and 6 at the same time for 5 seconds until the red LED is on.
- Look up the 5-digit code you would like to change. The pre-programmed code is 0 0 0 0 0 .
- Enter the first 5-digit code using the digit buttons.
- If the light is off, a valid code is saved. Otherwise, the light will flash once, and then remains on for code re-entry.
- Operate the device with the remote. If your device responds correctly, it means you have entered the right code. Otherwise, repeat from Step 2, and enter the second code on the list.
Learn code from other remote
You must have an original remote for the Replacement Remote Control (RRC) to learn code from it.
-
Press and hold 1 and 6 at the same time for 5 seconds until the red LED light is on.
-
Enter the learning code 9 9 9 0 0 . The red LED light will flash once and then remain on.
-
Place the RRC and the original remote, head to head aiming at each other, on a flat surface.
-
On the RRC, press the button that you would like to learn a code from the original remote. The LED will flash twice and stay on.
-
On the original remote, press and hold the button that you would like to learn from for 2 seconds.
-
The LED will blink once and stay on if the learning was successful.
To learn another key, repeat Step 4.
To exit, press 1 and 6 at the same time. -
The LED will blink 6 times quickly if learning failed. Repeat Step 4 to learn again.
List of IR codes for Hisense TV and Philips TV
| Hisense TV | Hisense TV | Philips TV | Philips TV |
|---|---|---|---|
| 0 | 14 | 105 | 119 |
| 1 | 15 | 106 | 120 |
| 2 | 16 | 107 | |
| 3 | 17 | 108 | |
| 4 | 18 | 109 | |
| 5 | 19 | 110 | |
| 6 | 111 | ||
| 7 | 112 | ||
| 8 | Philips TV | 0 0113 | |
| 9 | 100 | 114 | |
| 10 | 101 | 115 | |
| 11 | 102 | 116 | |
| 12 | 103 | 117 | |
| 13 | 104 | 118 |
For detail product information please refer to our online user manual.
Specifications are subject to change without notice. Philips and the Philips
Shield Emblem have registered trademarks of Koninklijke Philips N.V. and are
used under license.
This product has been manufactured by and is sold under the
responsibility of MMD Hong Kong Holding Limited or
one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in
relation to this product.
Philips Replacement Remote Quick Start Guide SRP4050
Register your product and get support at
www.philips.com/support
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>