AGC B21A Wireless Label Printer Installation Guide

June 12, 2024
AGC

AGC B21A Wireless Label Printer

Product Information

The product is a device that has undergone radiated emission tests and AC power line conducted tests. The tests were conducted to measure the device’s electromagnetic emissions in different frequency ranges.

Test Setup Photos

  • Radiated Emission Test Setup Below 30MHz: This test setup was used to measure the device’s radiated emissions below 30MHz. Refer to the corresponding photo in the user manual.
  • Radiated Emission Test Setup Below 1GHz: This test setup was used to measure the device’s radiated emissions below 1GHz. Refer to the corresponding photo in the user manual.
  • Radiated Emission Test Setup Above 1GHz: This test setup was used to measure the device’s radiated emissions above 1GHz. Refer to the corresponding photo in the user manual.
  • AC Power Line Conducted Test Setup: This test setup was used to measure the device’s conducted emissions through the AC power line. Refer to the corresponding photo in the user manual.
  • RF Conducted Test Setup: This test setup was used to measure the device’s conducted emissions in the radio frequency range. Refer to the corresponding photo in the user manual.

Product Usage Instructions

To use the product correctly, please follow these instructions:

  1. Ensure that the device is properly connected to the power source, following the guidelines provided in the user manual.
  2. Refer to the test setup photos in the user manual to understand the different test setups used during the product’s testing phase.
  3. If you experience any issues with electromagnetic interference, it is recommended to follow the guidelines provided in the user manual to mitigate the problem.
  4. For further assistance or troubleshooting, refer to the contact information provided in the user manual.

By following these instructions, you can effectively use the product and minimize any potential electromagnetic interference issues.

TEST SETUP PHOTOS

RADIATED EMISSION TEST SETUP BELOW 30MHz AGC-B21A-Wireless-Label-Printer-
fig-1

RADIATED EMISSION TEST SETUP BELOW IGHzAGC-B21A-Wireless-Label-Printer-
fig-2

RADIATED EMISSION TEST SETUP ABOVE IGHzAGC-B21A-Wireless-Label-Printer-
fig-3AC POWER LINE CONDUCTED TEST SETUPAGC-B21A-Wireless-
Label-Printer-fig-4RF CONDUCTED TEST SETUPAGC-B21A-Wireless-
Label-Printer-fig-5End of Report
Any having not by authorized approver, or having tE•en altered without authorization, or having not been by the “Dedicated Stamp” is be invalid. Copying or excerpting portion ot, or altering the content of the report is not without the written authorization ot AGC. The test results presented in the report apply only to the tested sample. Any objections to report issued by AGC should be submitted to AGC within 1%ays after the issuance of the test report. Further enquiry of validity or verification of the test report should be addressed to AGC by agcOl@agccert.com.

Attestation of Global Compliance(Shenzhen)Co., Ltd
Attestation of Global Compliance(Shenzhen)Std & Tech Co., Ltd
Tel: +86-755 2523 4088 E—mail: agc@agccert.com Web: http://www.agccert.com/

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals