SUSSEX Circa Wall Top Instructions

June 12, 2024
SUSSEX

Circa
Wall top assemblySUSSEX Circa Wall Top

Rough in plumbing

  • Upon receiving, carefully unpack the Tapware; note some parts have been combined for packaging purposes.
  • Separate parts as shown in diagram. The Spindles are supplied with Hot and Cold indication.
  • Install the Spindles hand-tight until the seal of the Spindle makes contact with the seat.
  • To ensure a good seal is made; tighten the Spindle slightly more using an appropriate spanner. Do not overtighten.
  • Note, over-tightening the Spindles could damage the ceramic discs and in turn, void the manufacturer’s warranty.
  • Place the Fibre washer over the seated Spindle and fit the Locking Sleeve. (Tighten well).
  • Seal the wall around the Locking Sleeve and immediately fit the Dress Ring.
  • Fit the Handle Body, the Handle Body must be fully engaged onto the Spindle; note the Set Screw contact point. (See diagram)
  • A mild adhesive can be applied to the Set screw when securing to the spindle.
  • Secure the Handle body by tightening the Set screw using the 2mm Allen key provided. (Tighten well)
  • After completing the installation, establish water supply, check function of Tapware and ensure no water leaks.

Product code

RWTA Wall top assembly
RWTA-V Wall top assembly – Vertex

Rough in (new wall breech)

  • A standard Wall Breech (not supplied) is to be used in conjunction with this Tapware.
  • Prepare a nogging to be fitted 30 – 35mm back from the front of the stud for the fixing of the Wall Breech (as shown).
  • When fixing the Breech to the nogging; ensure the Tap seats of the Breech will be level and square to the Finished Wall.
  • To ensure the Tapware will fit correctly the thickness of the finished wall coverings must be calculated prior to “Rough In”.
  • When using thicker than normal wall covering, position the breech as forward as possible to ensure the Tapware will fit.

Using existing breech (changing tapware only)

  • Remove the old Spindles and clean surrounding area.
  • When installing new Spindles into old Breaching, it is highly recommended to use a re-seating tool to dress the Seat.
  • Ensure the Spindle Seat is clean, flat and free of any debris.
  • All lines must be completely flushed prior to fitting the Spindles.
  • The distance from the finished Wall surface to the top of the Tap Seat must be between 2 to 12mm (See diagram)
  • If the installation configuration is not with-in the dimensions as shown, alternative Spindles are available.
    Longer Spindles can be ordered from original place of purchase. Sussex Part No. SXSPEK (12mm longer than standard)
    NOTE: Seat or Breech Body extensions are NOT to be used in conjunction with this Tapware.
    Failure to adhere will void warranty.

AS/NZS 3718:2005
LIC. 20081
Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS 3500:2003
Recommended working water pressure 300-500 kpa. Maximum water temperature is 65 deg.c
Copyright © Sussex Taps.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals