Alecto DVM149GN Video Baby Monitor Instruction Manual
- June 12, 2024
- Alecto
Table of Contents
Alecto DVM149GN Video Baby Monitor Instruction Manual
1. WARNINGS & SAFETY INSTRUCTIONS
- Read and keep the instructions. All the safety and operating instructions should be read before use.
- To use your parent unit and baby unit together, you must be able to establish a radio link between them.
- The range will be affected by environmental conditions. Any large metal objects, reinforced concrete, other solid structures, radio or electrical equipment between the baby and parent unit may block the radio signal.
- The use of other 2.4GHz products may cause interference with this product, so keep the baby unit away at least 1.5 meter from these type of products or turn the products off if they appear to be caused interference.
- This device can’t replace responsible adult supervision.
- This device is designed for indoor use only.
- The units should not be exposed to rain or moisture.
- The units should not be exposed to direct heat sources.
- This product is not a toy and should be kept out of children’s reach.
- This product contains small parts, take care when unpacking and assembling the product.
- Children can become entangled in the cords, therefore power cords should be kept more than 1 meter away from the crib and baby’s reach at all times.
- The baby units with power cords should never be hung on or near the crib.
- The units should only be used with the AC power adapters included in this package (rated 5V; 1.0A).
- Improper or incorrect use of batteries may cause corrosion or battery leakage, which could cause personal injury or damage to property. Use only the types of the batteries which are indicated in this manual.
- Don’t use the units if the cord or plug is damaged.
- Don’t attempt to repair or adjust any of the electrical or mechanical functions of the unit, if you do, the guarantee will be made void.
- This product should not be used on or under surfaces that may block the ventilation openings.
- This product must not be placed in an enclosed area that may impede the air flow.
2. MODE OPERATION
3. MENU OPERATION
3.1 Pairing the baby unit and parent unit
The baby unit is pre-registered to your parent unit. You don’t need to
register it again unless the baby unit loses its link with the parent unit. To
re-register your baby unit, or register a new baby unit, follow the
instructions below.
Note: Before you begin pairing, be sure to have the parent unit and baby unit side by side.
3.3 VOX setting / ECO Mode
This mode allows you to control the sound activation of your baby unit and
switch on the ECO mode. If there is no sound around the baby unit within 30
seconds, the sound transmission stops and the picture turns black. When the
baby unit detects any sounds louder than the sensitivity level, the sound and
image will turn on again. To change the VOX level, please follow the below
instructions.
Note 5: If you don’t turn off the alarm, the alarm will ring for 1 minute. After three minutes the alarm will ring again for 1 minute. The alarm will ring for three times in total, after this the alarm goes off.
4. TROUBLE SHOOTING
5. SPECIFICATIONS
DECLARATION OF CONFORMITY
Hereby, Commaxx declares that the radio equipment type Alecto DVM149GN is in
compliance with directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
http://DOC.hesdo.com/DVM 149GN_D0C.pdf
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>