JUST WIRELESS 20019-M Magnetic Charging Power Bank User Manual
- June 12, 2024
- JUST WIRELESS
Table of Contents
JUST WIRELESS 20019-M Magnetic Charging Power Bank
Power Bank Layout
Suitable for
- Smartphones
- Smartwatches, fitness trackers, digital cameras
- Portable Bluetooth devices
- Portable hand-held gaming consoles
Features
- Capacity: 5000mAh Magnetic Power Bank
- Battery type: Lithium polymer Rechargeable more than 300 times Includes Micro-USB cable for charging Built-in overcharging and short circuit protection
- Input: Micro/USB-C*: DC 5V 2A
- Output: USB – DC 5V 2.4A max / Wireless 5W
- Charging time: About 3-4 hours
Bluetooth and associated product marks are the trademarks of independently owned and operated companies. This product has not been licensed or endorsed by the manufacturer of Bluetooth products. MagSafe is a trademark of Apple Inc., registered in the U.S. and other countries. USB-C° is a registered certification mark of the USB Implementers Forum.
To Charge Power Bank
Charge via USB Wall Charger
- Using the included Micro-USB cable, connect the USB connector to an AC wall adapter or USB port on a computer.
- Connect the Micro-USB connector to the input connector on the Power Bank.
- During charging, the LEDs will flash to show charging status.
- When charging is complete, the LEDs will be permanently on.
- Additionally, USB-C°input can be used to charge the Power Bank using a standard USB-C® cable.
To Charge Phone or USB Device
- To Charge a Mobile Phone or other USB Device by cable
- Charge by Wireless Output MaqSafe® Compatible Devices
- Using your phone or other USB device’s charging cable, connect the USB Type A connector to the Output connector on the Power Bank.
- Connect the other end of the cable to your device.
- Charging should commence automatically.
- Pressing the power button will also start/stop charging.
- If your phone or device uses a standard Micro-USB connector then you can also use the included cable to charge your device.
- When your phone or device is fully charged, the Power Bank will automatically turn itself off.
- Wireless/magnetic charge applies only to phones that have this feature (MagSafe compatibility).
- Place the Power Bank on the back of the phone and align to verify charging has begun. Once the Power Bank is connected make sure to have the USB ports facing down for better contact.
To Check Remaining Capacity
- Press On/Off button and LEDs will light to show remaining capacity.
- The LEDs will turn off automatically after about 35 seconds or pressing On/Off button twice will turn off the LEDs immediately.
Important Safety Instructions
- To maximize battery life span, fully charge Power Bankbefore first use.
- Store Power Bank in a cool and dry place.
- Do not store Power Bank in hot or humid environment.
- Do not charge and discharge at the same time.
- Do not charge Micro-USB and USB-C° at the same time.
- Operating temperature should be between 14F to 104F.
- If Power Bank is not used for long periods of time, you should charge and discharge once every three months.
- When charging a device, the Power Bank may feel warm, this is a normal operating condition and should not be cause for concern.
- In normal conditions, the battery performance will decline over several years.
- Do not dispose of Power Bank in heat or fire.
- Do not clean Power Bank with harmful chemicals or detergents.
- Misuse, dropping or excessive force may cause product damage.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected,
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The distance between the user and products should be no less than 20cm FCC Radiation Exposure Statement – The device has been evaluated to meet general RF exposure requirements.
For Warranty information, please visit our website.
www.justwireless.com © 2023 Just Wireless SKU
20019-M REV052023 Made in Malaysia Printed black & white, one-sided & folded
accordion style with Photo Image page as front. Each page is 57mm by 100mm or
paper is 285mm across by 100mm high when cut for folding.
NOTE: Red lines are die-line guide (on its own layer) to be deselected
before printing.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>