VISUAL COMFORT MF 5351 Clifford 26 Inch Sculpted Hanging Shade Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
ASSEMBLY INSTRUCTIONS
- Bulbs not included
- (Packaged separately)
Clifford 26″ Sculpted Hanging Shade
Item # MF 5351
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver Slotted Screwdriver Chain Pliers
Slip Joint Pliers Measuring Tape Wire Cutters
Wire Strippers Scissors
1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Loosen screw (F) on quick link (E) , then remove collar loop
(D) from chain (I).
3. Install mounting plate (B) to the junction box and secure with
mounting screws (C).
4. Secure collar loop (D) to mounting plate (B) using pliers to
tighten locknut.
5. Install canopy (G) to collar loop (D) and secure with collar ring
(H).
6. Determine desired overall length, and amount of chain (I) needed.
Shorten chain using chain pliers. (Keep extra chain)
7. Loosen screw (F) on quick link (J) , then attach chain (I) to
collar loop (D) and fixture (K) using quick links ( E & J).
Tighten with screws (F). See diagram 1 & 2.
8. Thread fixture wire and ground wire through chain (I).
NOTE: When you reach the collar loop (D) , ensure there is no tension
on the wires. Cut excess wires, being sure to leave enough to reach the
junction box.
9. Separate two sides of molded wire, and strip insulation on each 5/8″.
10. Loosen collar ring (H) and let canopy (G) slip down chain (I)
carefully.
11. Twist all fixture wires together. Slip through center hole of collar loop
(D).
NOTE: Untwist wires and separate to prepare for connection.
12. Wrap fixture ground wire (bare copper) around the green grounding screw
(see diagram 3). Tighten. Continue fixture ground wire and connect to supply
ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded.
13. Connect fixture neutral wire (ribbed) to the supply neutral wire (usually
white) using wire nut (A).
14. Connect fixture hot wire (smooth with markings) to the supply hot wire
(usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections.
15. Make sure all wire connections are tight, then carefully tuck into the
junction box.
16. Install canopy (G) to collar loop (D) and secure with collar ring
(H).
17. Install light bulbs into the sockets.
18. Remove shade (M) from packaging, then attach shade (M) to fixture
(K) and secure with screws (L).
NOTE: If shade has additional packaging, carefully cut off from interior
of shade to avoid damages.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do Not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>