VISUAL COMFORT KW 2287 Large Vanity Sconce Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
Rousseau Large Vanity Sconce
Item # KW 2287
ASSEMBLY INSTRUCTIONS
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
| Phillips Screwdriver | Slotted Screwdriver |
|---|
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (A) from fixture by removing screws (C).
-
Install mounting plate (A) to junction box and secure with mounting screws (B).
-
Connect supply ground wire (usually green or bare copper) around the green grounding screw (see diagram 1). Tighten.
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (G).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (G).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture to mounting plate (A) and secure with screws (C).
-
Thread shades (F) to fixture body (E). See diagram 2.
NOTE: Do not over-tighten otherwise shade could become damaged.
Care Instructions : Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>