VISUAL COMFORT MF 2201 Wimberley Double Library Wall Light Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
- VISUAL COMFORT MF 2201 Wimberley Double Library Wall Light Instruction
- ASSEMBLY INSTRUCTIONS
- ASSEMBLY INSTRUCTIONS
- Wimberley Double Library Wall Light
- NOTICE:
- TOOLS REQUIRED (NOT INCLUDED):
- Bulb not included
- Wimberley Double Library Wall Light
- NOTICE:
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
VISUAL COMFORT MF 2201 Wimberley Double Library Wall Light Instruction
Manual
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
Wimberley Double Library Wall Light
Item # MF 220
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver Slotted Screwdriver Scissors
Bulb not included
- Carefully remove all parts from the Place on a clean, soft surface.
- Remove mounting plate (A) from fixture (D) by removing screws (E).
- Install mounting plate (A) to the junction box and secure with mounting screws (B).
- Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (C).
NOTE: It is imperative that the fixture is grounded.
- Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (C).
- Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (C).
CAUTION: Do not reverse the hot and neutral connections.
- Make sure all wire connections are tight, then carefully tuck into the junction
- Install fixture (D) to mounting plate (A) and secure with screws (E).
- Remove socket ring (H) from socket (F).
- Remove shade (G) from packaging and install to socket (F) by securing with socket ring (H).
NOTE: If shade has additional packaging, carefully cut off from interior of shade to avoid damages.
Wimberley Double Library Wall Light
Item # MF 220
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install. Retain
all packaging material until installation is complete and approved.
11. Loonsen knobs (J) to adjust fixture to desired position, then tighten
knobs (J).
12. Install light bulb into socket.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not
use abrasive or chemical agents.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>