OHLINS DU 126 Shock Absorber for Ducati Monster Instruction Manual
- June 4, 2024
- OHLINS
Table of Contents
OHLINS DU 126 Shock Absorber for Ducati Monster
Note!
- Please note that there can be small differences between your product and the images in these instructions.
- Please note that during storage and transport, especially at high ambient temperature, some of the oil and grease used for assembly may leak and stain the packaging. This will not cause damage to the product, wipe off the excessive oil or grease with a cloth.
- Before you install this product, check the kit contents. If anything is missing, please contact an Öhlins dealer.
- Before you install this product, read the Öhlins Owner’s manual. This product is an important part of the vehicle and the vehicle stability.
Kit Contents
Description| Part No| Pcs
Shock absorber| DU 126| 1
Sticker “Memo notes”| 01180-01| 1
Sticker set| 10207-01| 1
Owner´s manual| 07241-02| 1
MOUNTING INSTRUCTIONS
- Warning! If you work with a lifted vehicle, make sure that it is safely supported to prevent it from tipping over.
- Note! When you work with this product, see the vehicle service manual for vehicle specific procedures and important data.
- Note! Before you install this product clean the vehicle.
- Put the motorcycle on a work stand or lift it so that the rear wheel barely touches the ground.
- Remove the upper right hand screw to the rear subframe.
- Remove the lower and upper screw to the std shock absorber.
- Remove the std shock absorber.
- Mount the Öhlins unit with the cylinder head/preload adjuster at the swing arm and the damping adjuster end at the frame. The preload adjuster should point to the left hand side. Fasten the rear subframe screw.
Note! Lower the vehicle so that the suspension is slightly compressed before
you tighten the screws.
Caution! Make sure that you tighten all screws to the correct torque and that
nothing fouls or restricts movement of the shock absorber when the suspension
is fully compressed or extended.
ADJUSTMENTS
Warning! Before you ride/drive, always make sure that the setup is according to the recommended setup data. Read about adjustments and setting up in the Öhlins Owner’s Manual before you make any adjustments. Contact an Öhlins dealer if you have any questions about setting up.
SETUP DATA
| Length | 294 | mm |
|---|---|---|
| Stroke | 60 | mm |
| Rebound | 14 | clicks |
| Spring preload | 6 | mm |
Recommended Free sag and Ride height
R1-R2| |
R1-R3| 50| mm
F1-F2| |
F1-F3| 47| mm
Öhlins products are subject to continuous improvement and development,
therefore, although these instructions include the most up-to-date information
available at the time of printing, minor updates may occur.
© Öhlins Racing AB. All rights reserved. Any reprinting or unauthorized use
without the written permission of Öhlins Racing AB is prohibited.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>