OHLINS YA 583 Yamaha Tracer 9 Shock Absorber Instructions

June 4, 2024
OHLINS

OHLINS YA 583 Yamaha Tracer 9 Shock Absorber

Note!
Please note that there can be small differences between your product and the images in these instructions.

Note!
Please note that during storage and transport, especially at high ambient temperature, some of the oil and grease used for assembly may leak and stain the packaging. This will not cause damage to the product, wipe off the excessive oil or grease with a cloth.

Kit Contents

Description| Part No| Pcs
Shock| YA583| 1
Tie-rap| 00231-01| 2
Screw M6x22| 01046-05| 2
Screw M6x12| 01046-36| 2
Screw M6x14| 00382-16| 1
Bracket| 01165-26| 1
Bracket| 03102-21| 1
Sticker set Öhlins|  | 1
Owners manual| 07241-02| 1

Note!
Before you install this product, check the kit contents. If anything is missing, please contact an Öhlins dealer.

Warning!
Before you install this product, read the Öhlins Owner’s manual. This product is an important part of the vehicle and the vehicle stability.

MOUNTING INSTRUCTIONS

Warning!
We strongly recommend to let an Öhlins dealer install this product.

Warning!
If you work with a lifted vehicle, make sure that it is safely supported to prevent it from tipping over.

Note!
When you work with this product, see the vehicle service manual for vehicle specific procedures and important data.

Note!
Before you install this product clean the vehicle.

  1. Put the motorcycle on a work stand so that the rear wheel barely touches the ground.
  2. Remove the front shock absorber attachment screw.
  3. Remove the rear shock absorber attachment screw. Remove the original shock absorber.
  4. Install the shock absorber with the valve down, hoses on the left side led towards the back of the vehicle (see figure). Install the rear shock absorber attachment first.
  5. Install the front shock absorber attachment screw.
  6. Remove the left passenger foot peg. Mount the supplied bracket between the foot peg and the frame (see figure).
  7. Install the pre-load adjuster and compression adjuster according to the figure. Use the supplied screws. Apply thread lock on the thread.
  8. Fasten the hoses with cable ties if necessary. Make sure that the hoses runs without sharp bends and that the hose is not squeezed when the rear suspension is compressed or extended.

OHLINS YA 583 Yamaha Tracer 9 Shock Absorber-FIG2

ADJUSTMENTS

Warning!
Before you ride/drive, always make sure that the setup is according to the recommended setup data. Read about adjustments and setting up in the Öhlins Owner’s Manual before you make any adjustments. Contact an Öhlins dealer if you have any questions about setting up.

SETUP DATA

Length 327 mm
Stroke 71.5 mm
Rebound 16 clicks
Compression 10 clicks
Spring preload 9 mm
Spring 01096-41
Spring rate 115 N/mm
Spring free length 190 mm

To find the latest information contact an Öhlins distributor. Please contact Öhlins if you have any questions regarding the contents in this document.

Öhlins Racing AB Box 722 S-194 27 Upplands Väsby, Sweden Phone +46 8 590 025 00 fax +46 8 590 025 80

www.ohlins.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals