BTCSTAR BTC28054NS 4 Inch Centerset Double Handle High Arc Bathroom Sink Faucet Installation Guide
- June 12, 2024
- BTCSTAR
Table of Contents
BTCSTAR BTC28054NS 4 Inch Centerset Double Handle High Arc Bathroom Sink
Faucet
Product Information:
This product is a spout assembly with handles that is designed to be installed
on a sink. It comes with a gasket, bracket, nut, washers, threaded rings,
quick connects, and hoses. The spout assembly is made to fit through a sink
opening and
secure in place using the provided bracket and nut. The handles are attached
to the spout assembly using washers and threaded rings. The quick connects are
used to connect the spout assembly to the water supplies. This product is
suitable for both hot and cold
water supplies.
Product Usage Instructions:
- Fit the gasket onto the underside of the spout.
- Insert the spout through the sink opening.
- Slide the bracket and washer onto the stud.
- Thread the nut onto the stud and tighten.
- If the sink is uneven, use silicone under the gasket for a secure fit.
- Loosely attach each handle to the spout assembly using a washer and a threaded ring. Ensure that the handles are in the OFF position.
- Align the handles as shown in the diagram.
- Align tabs (1) and tabs (2) on the quick connects.
- Push the quick connects firmly upward and snap them onto the receiving tube tab (1). Pull down moderately to ensure each connection has been made.
- Connect the product to the water supplies using the provided hoses.
- Turn on the water supplies.
- Check all connections for leaks. Please note that these instructions are a summary of the user manual. For detailed installation steps and safety precautions, refer to the complete user manual that came with the product.
TOOLS
Installation Guide
-
Fit the gasket onto the underside of the spout. Insert the spout through the sink opening.
Slide the bracket and washer onto the stud Thread the nut onto the stud and tighten.
or
Place spout with gasket through mounting hole in sink. Secure spout with bracket and nut. Note: If sink is uneven, use silicone under the gasket. -
Loosely attach each handle with a washer and a threaded ring.
Ensure the handles are in the OFF position Align the handles as shown.
- Align tabs (1) and tabs (2) on quick connects (3). Push quick connects firmly upward and snap onto receiving tube tab (1). Pull down moderately to ensure each connection has been made.
- Connect To Water Supplies.
- Turn on the water supplies.Check all connections for leaks.
