OLIGHT BFL 1800 Rechargeable 1800 Lumens Bike Headlight User Manual
- June 12, 2024
- OLIGHT
Table of Contents
USER MANUAL BFL 1800
Thank you for purchasing this Olight Product.
Please read this manual carefully before use and keep it for future reference!
IN THE BOX
SPECIFICATIONS
- All above specifications are test results based on ANSI/NEMA
FL1-2009 Standard. The runtimes are recorded while tested in a 25km/h wind.
USB Magnetic Charging Cable — MCC1AL
Parameter | Specification |
---|---|
Charging cable | USB type A – magnetic charging connector, length: 1.2m |
Input | USB A – Type DC 5V 1A |
Charging pattern | CC&CV |
Maximum charging current | 1A |
Voltage of fully charged battery | 4.2V±0.05V |
Time to fully charge | 5.5h |
Charge indication | Red: charging Green: full (over 95%) or disconnected with |
bike light
BEFORE FIRST USE
The bike light arrives in lockout mode for shipping purposes. Before first use, please press and hold down the power button for 5 seconds to unlock. If the power button is pressed less than 5 seconds in lockout mode, the power button will flash red to signal that the light is still in lockout mode.
CHARGING
Before first use please fully charge the product. Connect the magnetic USB end of the charging cable to an external USB power source, then attach the other end of the magnetic charging cable to the charging port. It takes no more than 5.5 hours to fully charge the light (For reference only. When the USB power source is insufficient to provide 5V 1A power capacity, the charging time will be longer). The red indicator means charging, while the green indicator means charging completed (battery power>95%).
BATTERY INDICATOR
- When unlocked and turned off, single press the power button, and the battery level indicator will turn on to display the battery level. When the indicator flashes red (battery level ≤10%), the bike light will only produce low light output and cannot be switched to other modes.
HOW TO INSTALL
HANDLEBAR MOUNT INSTRUCTIONS
- The handlebar mount comes with 4 straps in different lengths, including No.2, No.3, No.5 and No.6 straps, to suit different handlebars.
- Strap No.2 is suitable for handlebars with a diameter of 1 inch/25.4mm.
- Strap No.3 is suitable for handlebars with a diameter of 1.10 inches/28mm.
- Strap No. 5 is suitable for handlebars with a non-circular cross section.
- Strap No.6 is suitable for handlebars with a diameter of 1.25 inches/31.8mm.
- The maximum torque applied to the tightening screw in the handlebar mount cannot exceed 0.5N.m.
DANGER
-
DO NOT shine the light directly into human eyes. This may cause temporary blindness or permanent damage to the eyes.
-
DO NOT cover the bike light’s head or place the head on the ground when the bike light is on. The radiation energy may cause damage to the bike light itself, or even result in the burning of flammable objects nearby.
WARNING -
Keep out of reach of children.
-
DO NOT activate high mode repeatedly under high temperature to prevent the bike light body from overheating and potentially leading to injury.
NOTICE -
Please keep the charging port clean and dry before charging and maintain it regularly.
-
The bike light adopts a built-in battery which cannot be replaced by the owner. If the battery has been damaged, please contact the customer service team to return it for repair according to the warranty terms.
EXCLUSION CLAUSE
Olight is not liable for damages or injuries sustained resulting from the
usage of the product inconsistent with the warnings in the manual, including
but not limited to using the product inconsistent with the recommended lockout
mode.
HOW TO OPERATE
ON/OFF: Long press the power button to turn the light on or off. When the
light is turned on, it will return to the mode used previously.
CHANGE BRIGHTNESS LEVEL: While the light is already on, single click the
power button to change brightness levels. Starting from the present brightness
level, it will cycle through low, medium, and high mode with each single
click. LOCKOUT/UNLOCK: When the light is turned off, press and hold the
power button for over 5 seconds until the indicator flashes red to access the
button lockout mode (the light will briefly turn on and then switch off to
signal the lockout mode). To unlock it, press and hold the power button for
over 5 seconds again until the light turns on.
EU-DECLARATION OF CONFORMITY
EU-Declaration of Conformity can be found here: https://olightworld.com/ec- declaration
WARRANTY
Within 30 days of purchase: Contact the original seller for repair or
replacement. Within 2 years of purchase: Contact Olight for repair or
replacement.
MCC Magnetic USB Charging Cable: One year. This warranty does not cover
normal wear and tear, modifications, misuse, disintegrations, negligence,
accidents, improper maintenance, or repair by anyone other than an Authorized
retailer or Olight itself.
USA Customer Support
cs@olightstore.com
Global Customer Support
customer-service@olightworld.com
Visit www.olightworld.com to see our
complete product line of portable illumination tools.
Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan
Road, Changan Town, Dongguan City, Guangdong, China.
Made in China
References
- Olight | Illuminate Your World.
- Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>