OLIGHT M-Lok Rail Mount Javelot Tac User Manual
- June 12, 2024
- OLIGHT
Table of Contents
M-Lok Rail Mount Javelot Tac
User Manual
Thank you for purchasing this Olight product. Please read this manual carefully before use and keep it for future reference!
IN THE BOX
SPECIFICATIONS
All above
specifications are test results based on ANSI/NEMA FL1-2009 Standard. The
tests are performed using the battery included in the flashlight.
USB MAGNETIC CHARGING CABLE — MCC1A
| Parameter | Specification |
|---|---|
| Charging cable | USB type A – magnetic charging connector, |
length: 0.5m
Input| USB A – Type DC 5V 1A
Charging pattern| CC&CV
Maximum charging current| 1A
Voltage of fully charged battery| 4.2V±0.05V
Time to fully charge| 3.1 hours (For reference only)
Charge indication| Red: charging
Green: full or disconnected with flashlight
PRODUCT OVERVIEW
BEFORE FIRST USE
Please remove the protective film on the lens; and please also unscrew the
tailcap to remove the insulating film within the battery compartment, then
screw the tailcap back on tightly. If the battery needs to be replaced, make
sure that the positive end of the new battery faces the flashlight head when
you put it in. 
CHARGING
VIBRATING POWER INDICATOR
Alerting you if the battery is low: power<30% vibrate once every 5 minutes;
power<10% vibrate twice per minute; power< 5% vibrate three times every 10
seconds.
* Before first use please fully charge the
product.
- Connect the USB end of the magnetic charging cable to an external USB power source, then attach the other end of the cable to the charging port of the light (best charging efficiency with a USB power source of no less than 5W (5V 1A) . The red indicator means charging, while the green indicator means charging completed.
PRODUCT INSTALLATION
a. Loosen the knob locking lever on the rail mount (counter clockwise) until
it stops.
b. Adjust the width of the rail mount opening
by pushing the knob locking lever (Note: Do not put your fingers against the
movable rail mount on the opposite side of the knob locking lever).
c.
Place the T-mount on the product into the T-shape inside the rail mount. (The
two screws on the rail mount align with the slots on the product’s
T-mount).
d.
Lastly, lock the knob locking lever on the rail mount with tools to make it
ready for use (turning it clockwise).
e. To remove the product, loosen the knob
locking lever on the rail mount and push it to adjust the width of the rail
mount opening and remove the product.
REMOTE SWITCH INSTALLATION
a. Attach the magnetic remote switch to the tail of the product (make sure the
detent ring of the remote switch is unlocked). 
MAGNETIC REMOTE SWITCH
Quickly
single click the button to turn the flashlight ON/OFF. When you press and hold
the button, the flashlight will be in momentary-on mode; when you release the
button, it will turn off.
WARNING
- Do not use damaged, deformed battery, or with broke sleeve.
- Do not short the charging port with metallic object intentionally.
- Keep the battery removed properly, don’t store the battery together with metallic objects such as coins, or screws.
CAUTION
- Do not look directly at the light source or shine to eyes, may cause temporary blindness or permanent damage to the eyes.
- Do not block the light outlet at close range, the energy emitted from the light may cause the object to burn.
- Do not charge the light with any other non-specified chargers.
- Do not leave the light in a car where the inside of temperature may be over 60℃, or in similar places.
- Dedicated battery, do not take it out for charging.
- CAUTION HOT: Do not touch the hot surface place, it may cause skin burns.
HOW TO OPERATE
Click the tail switch lightly to produce a low light output or press the tail
switch hard to produce a high light output.
Single click (click and release quickly) the tail switch to turn the
flashlight on or off.
When you press and hold the switch, the flashlight will be in momentary mode;
when you release the tail switch, it will turn off.
WARRANTY
Within 30 days of purchase: Contact the original seller for repair or
replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery warranty: Olight offers a one year warranty for all rechargeable
batteries.
USB magnetic charging cable: One year.
For any of the fragile or low-value fittings not covered above, like wrench
and self-locking bands, you can contact the
post-sale within 30 days of the purchase, if it has any quality drawback or
damage under normal use condition. If such drawback or damage occurs after 30
days of the purchase or under abnormal use condition, we will only offer
conditional quality assurance as appropriate.
USA Customer Support
cs@olightstore.com
Global Customer Support
customer-service@olightworld.com
Visit www.olightworld.com to see our complete
product line.
Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road,
Changan Town, Dongguan City, Guangdong, China.
Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>