InCarTec 29-CTSKK004 Skoda Steering Wheel Control Interface Instruction Manual

InCarTec 29-CTSKK004 Skoda Steering Wheel Control Interface

Product Information

• Product Name: Skoda Steering Wheel Control Interface
• Product Code: 29-CTSKK004
• Vehicle Application: Skoda Yeti (5L) 2014>
• Description : This product is an analogue steering wheel control interface designed for Skoda Yeti car models. It allows you to control various functions of your aftermarket head unit using the buttons on your steering wheel.

ABOUT THIS PRODUCT

29-CTSKK004
Analogue Steering Wheel Control Interface for Skoda Yeti car models

Wiring Colour Codes:

• Purple – Right Rear Speaker +
• Purple/Black – Right Rear Speaker –
• Green – Left Rear Speaker +
• Green/Black – Left Rear Speaker –
• Grey – Right Front Speaker +
• Grey/Black – Right Front Speaker –
• White – Left Front Speaker +
• White/Black – Left Front Speaker –
• Yellow – Permanent 12V
• Black – Ground
• Red – Ignition 12V

PRIOR TO INSTALLATION

Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. Please ensure that the correct tools are using during the installation to avoid damage to the vehicle or product.

Product Usage Instructions

1. Read the manual prior to installation. Ensure you have the necessary technical knowledge for installation.
2. Choose a place for installation that is free of moisture and away from heat sources.
3. Use the correct tools during installation to avoid damage to the vehicle or product.
4. Remove and disconnect the original head unit.
5. Connect the 12-way molex connector of the head unit patch lead (supplied separately) to the interface.
6. Connect the opposite end of the head unit patch lead to the head unit steering wheel control input on the back of the aftermarket head unit. Note: This may be a 3.5mm jack plug or a wire input depending on the head unit brand. Refer to the head unit installation manual for further information.
7. Important: Complete the previous step before connecting power to the interface to ensure steering wheel control function.
8. Connect the 14-way molex connector to the interface.
9. Connect the male power/speaker ISO harness to the female power/speaker ISO harness from the aftermarket head unit. For aftermarket head units without an ISO connector, refer to the Wiring Colour Codes on Page 2.
10. Connect the female vehicle-specific connectors on the harness to the male vehicle connector from the vehicle.
11. Test the head unit for correct operation.

FITTING GUIDE

1. Remove and disconnect the original head unit.

2. Connect the 12 way molex connector of the head unit patch lead (supplied separately) to the interface.

3. Connect the opposite end of head unit patch lead to the head unit steering wheel control input on the back of the aftermarket head unit.
   NB: This may be a 3.5mm jack plug or a wire input depending upon the head unit brand being fitted. Please see the head unit installation manual for further information on where to connect.
   Important: This step must be completed before connecting power to the interface. Failure to so do may result in no steering wheel control function.

4. Connect the 14 way molex connector to the interface

5. Connect the male power/speaker ISO harness to the female power/speaker ISO har-ness from the aftermarket head unit. For aftermarket head units without an ISO connector, please refer to “Wiring Colour Codes” on Pg. 2.

6. Connect the female vehicle specific connectors on the harness to the male vehicle connector from the vehicle. Test head unit for correct operation.

Steering Wheel Control Functionality

The information provided in this document is subject to change without notice due to manufacturer changes and/or improvements to the product/s.

Retains Steering Wheel Controls (if equipped)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>