Purse Pets T26700_0046_20139590 Metallic Magic Puppy Instruction Manual
- June 12, 2024
- Purse Pets
Table of Contents
1 Purse Pets™ Purse, 1 Instruction Sheet
3 x AAA (LR03) 1.5 V, 1,5 V
Included
SETUP
TRY-ME
PRESS BUTTON TO CHANGE MODES
ON-THE-GO MODE
MAGIC MODE
SLEEP MODE
INSTRUCTIONAL VIDEOS!
WWW.SPINMASTER.COM
CUSTOMERCARE@SPINMASTER.COM
SETUP – TAKE THE PURSE OUT OF “TRY ME” BY MOVING THE POWER SWITCH TO THE ON (I) POSITION.
- Unzip purse to access battery compartment.
- Open the battery door with a screwdriver. Remove used batteries by pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools.
- Install new batteries as shown in the diagram (+/-).
- Replace battery door. Check your local laws and regulations for correct recycling and/or battery disposal.
Note: Batteries included are for in-store demonstration and should be
replaced to improve performance.
MUTE MODE: Hold insignia button while turning the purse on. To exit MUTE
MODE, turn the purse OFF and ON again.
Press insignia button to switch between modes:
-
ON-THE-GO MODE
A. Press my forehead and I will blink and make noises.
B. I will blink while we are on the go.
C. Press and hold my forehead and my eyes will blink rapidly while I make camera noises and chime in excitedly. -
MAGIC MODE
A. Shine Collector: 1. Press my forehead to try your luck. I will close my eyes and make a roulette sound. 2. When the sound stops I will let you know if you lost, won
a little or won A LOT!
B. Runway Ready REMIX: 1. Press and hold my forehead to play runway music. 2.
Press my forehead to add a DJ sample to the music. 3. Press and hold my forehead and I will sing along with the music. -
SLEEP MODE
I will enter sleep mode if we don’t interact for approximately 5 minutes.
A. You can put me to sleep by holding my insignia button.
B. Press my insignia button and I will wake up.
For TROUBLESHOOTING questions and solutions, please visit our website:
PursePets.com
NOTE: If normal function of the product is disturbed or interrupted,
strong electromagnetic interference may be causing the issue. To reset
product, turn it completely off, then turn it back on. If normal operation does
not resume, move the product to another location and try again.
To ensure normal performance, change the batteries, as low batteries may not
allow full function.
Safety Precautions:
- Remove batteries when not in use.
- Parental guidance is recommended for the play.
- New alkaline batteries are recommended to obtain maximum performance.
Note: Parental guidance is recommended when installing or replacing
batteries. Under the environment with electrostatic discharge, the toy may
malfunction and require user to reset the toy.
CARE AND MAINTENANCE: Always remove batteries from the toy when it is not
being used for a long period of time. Wipe the toy gently with a clean damp
cloth. Keep the toy away from direct heat. Do not submerge the toy in water.
This can damage the electronic assemblies.
Requires 3 x 1.5 V AAA (LR03) batteries (included). Batteries or battery packs must be removed for recycling and proper disposal. When this product has reached the end of its useful life, it should not be disposed of with other household waste. EU legislation for Electrical and Electronic Equipment and Batteries, requires these to be separately collected so that they can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council.
BATTERY SAFETY INFORMATION:
Batteries are small objects. Replacement of batteries must be done by adults.
Follow the polarity (+/-) diagram in the battery compartment. Promptly remove
dead batteries from the toy. Dispose of used batteries properly. Remove
batteries for prolonged storage. Only batteries of the same or equivalent type
as recommended are to be used. DO NOT incinerate used batteries. DO NOT
dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old
and new batteries or types of batteries (i.e. alkaline/standard/rechargeable).
Using rechargeable batteries is not recommended due to possible reduced
performance. Rechargeable batteries are only to be charged under adult
supervision. Replaceable-rechargeable batteries are to be removed from the toy
before being charged. DO NOT recharge non-rechargeable batteries.
DO NOT short-circuit the supply terminals.
FCC STATEMENT:
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for Class B digital devices
pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference to radio communications.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction, may cause harmful
interference to radio co mmunication. However, there is no guarantee that
interference will not occur in a particular installation. If this toy does
cause interference to radio or television reception (you can check this by
turning the toy off and on while listening for the interference), one or more
of the following measures may be useful:
- Reorient or relocate the receiving antenna
- Increase the separation between the toy and the radio or the TV
- Consult the dealer or an experienced TV-radio technician for help.
NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221. To contact the responsible party please visit fcc.spinmaster.com
Spin Master Ltd. reserves the right to discontinue the PursePets.com website
at any time.
Retain this information, addresses and phone numbers for future reference.
Do not change or modify anything on the toy.
Spin Master Logo & © Spin Master Ltd. All Rights Reserved.
⚠ WARNING: CHOKING HAZARD – Small parts. Not suitable for children under three years.
Before @rst use: Read the user’s information together with your child.
WWW.SPINMASTER.COM
customercare@spinmaster.com
Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221
Spin Master International B.V., Kingsfordweg 151, 1043 GR Amsterdam, NL
Spin Master Australia Pty Ltd, Suite 101, Level 1, 18-24 Chandos Street, St
Leonards, NSW 2065; ? 1800 316 982
Spin Master Toys UK Ltd. Boston House, Boston Drive, Bourne End,
Buckinghamshire, SL8 5YS, UK
T26700_0046_20139590_GML_IS_R2
T26700_0046_20139591_GML_IS_R2
T26700_0054_20140945_GML_IS_R2
T26700_0047_20139596_GML_IS_R2
Country of Origin – Placement
Factory according to production country to print Country of Origin (COO)
If corresponding country is not in below, contact Spin Master to provide
translation
| China | MADE IN CHINA |
|---|---|
| Vietnam | MADE IN VIETNAM |
| India | MADE IN INDIA |
| Mexico | MADE IN MEXICO |