Purse Pets 6064118 Print Perfect Instructions

June 3, 2024
Purse Pets

Purse Pets 6064118 Print Perfect

SETUP

Purse-Pets-6064118-Print-Perfect-FIG-1

I HAVE 3 MODES

ON THE GO MODE

Purse-Pets-6064118-Print-Perfect-FIG-3

MAGIC MODE

Purse-Pets-6064118-Print-Perfect-FIG-4

SLEEP MODE

Purse-Pets-6064118-Print-Perfect-FIG-5

INSTRUCTIONAL VIDEOS

SETUP

  1. Unzip purse to access battery compartment.

  2. Open the battery door with a screwdriver. Remove used batteries by pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools.

  3. Install new batteries as shown in the diagram (+/-).

  4. Replace battery door. Check your local laws and regulations for correct recycling and/or battery disposal.
    Note : Batteries included are for in-store demonstration and should be replaced to improve performance.

  5. Move the power switch to the ON (I) position.

MUTE MODE: Hold insignia button while turning the purse on. To exit MUTE MODE, turn the purse OFF and ON again. Press insignia button to switch between modes:

ON-THE-GO MODE

  1. A. Touch my forehead and I will blink and make noises.
  2. B. I will blink while we are on the go.
  3. C. Hold my forehead or hug me for some sweet snuggly sounds.

MAGIC MODE

  • A. Style Meter: Ask me what I think about something, then touch my forehead. I will let you know how much I like it and the audience will react.
  • B. Runway Ready REMIX: Hold my forehead to play runway music. Touch my forehead and I will contribute to the music. Hold my forehead and I will play a record scratch sound.

SLEEP MODE
I will enter sleep mode if we don’t interact for approximately 5 minutes. Press my insignia button and I will wake up. You can also put me to sleep by holding my insignia button

NOTE : If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely oN, then turn it back on. If normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.

Safety Precautions

Remove batteries when not in use. – Parental guidance is recommended for the play. – New alkaline batteries are recommended to obtain maximum performance.

Note : Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require user to reset the toy.

CARE AND MAINTENANCE

Always remove batteries from the toy when it is not being used for a long period of time. Wipe the toy gently with a clean damp cloth. Keep the toy away from direct heat. Do not submerge the toy in water. This can damage the electronic assemblies.

Requires 3 x 1.5 V AAA (LR03) batteries (included)
Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life, it should not be disposed of with other household waste. EU legislation for Electrical and Electronic Equipment and Batteries, requires these to be separately collected so that they can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up land¨ll space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council..

FCC STATEMENT

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy of and on while
listening for the interference), one or more of the following measures may be useful:

  • Reorient or relocate the receiving antenna
  • Increase the separation between the toy and the radio or the TV
  • Consult the dealer or an experienced TV-radio technician for help.

NOTE : Changes, adjustments or modi¨cations to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221. To contact the responsible party please visit fcc.spinmaster.com

CAUTION : Avoid wearing while riding bicycles, playing on slides/swings and similar moving objects to prevent entrapment Spin Master Ltd. reserves the right to discontinue the PursePets.com website at any time

WARNING : CHOKING HAZARD – Small parts. Not suitable for children under three years

Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada Spin Master Toys UK Ltd. Boston House, Boston Drive, Bourne End, Buckinghamshire, SL8 5YS, UK

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals