AVA SECURITY FLEX 2MP Camera User Guide
- June 12, 2024
- AVA SECURITY
Table of Contents
Mounting guide
SECURITY FLEX 2MP Camera
User Guide
Important warnings and safety instructions
Χ Avoid exposing the camera to shocks, high pressure or temperatures
above 40° C.
Χ Avoid placing the camera near fans, ventilation or other noise
sources. This will degrade audio performance.
Χ Avoid placing the camera near fans, ventilation, or other heat
sources. This will degrade sensor performance.
Χ Avoid scratching or leaving fingerprints on the lens, this
degrades image quality. If possible, keep the protective plastic on the lens
cover during installation.
Χ Do not clean the camera with harsh detergents, gasoline or
chemicals such as Acetone.
Χ Do not try to repair the unit yourself. Refer all servicing of
the camera to Ava or contact a reseller.
! Prolonged use of the white LEDs may affect sensor readings.
! This product should be supplied by a Power over Ethernet (PoE) Power
Sourcing Equipment (PSE) compliant with IEEE 802.3af or USB-C power source
rated 5V 1.5A. The power supply should be UL-listed and marked “Limited Power
Source”or “LPS”.
! The camera and the PoE PSE must be installed within the same building, as
described by Environment A of the IEEE 802.3af standard. The PoE PSE must be
properly grounded.
Box content
Screw dimensions
dh = 9.4 mm
l = 32 mm
d = 4 mm| Anchor dimensions
l = 25 mm
d= Ø6mm / ¼ ”
---|---
Required:
PH2 screw driver Drill with 6mm (1/4”) drill bit”
Cable routing alternatives
Installing the bracket
Attaching the camera and connecting the ethernet cable
Adjusting the ball joint and video stream
