PHANTEKS PH-R260 Glacier R260 Combo Reservoir Integrated Digital RGB Lighting Instruction Manual
- June 12, 2024
- PHANTEKS
Table of Contents
**
**
PHANTEKS PH-R260 Glacier R260 Combo Reservoir Integrated Digital RGB
Lighting
GLACIER R260
PH-R260_BK01 /PH-R260_MW01 /PH-R260_D5 BK01 /PH-R260_D5 MW01
- R260 Reservoir
- Fan Bracket
- Pump Bracket
- Stop Fitting (pre-installed)
- Plug Fitting (pre-installed)
- M3x8 Bracket Screws
- M4×25 Pump Screws (pre-installed)
- Fan Screws
- D-RGB cable
- D-RGB Motherboard cable
- 2.5mm Allen Key
DISCLAIMER
This product is intended for advanced users. Please consult with a qualified technician for installation. Phanteks assumes no liability for any damages occurring as a result of using Phanteks cooling products.
WARNING
- Power down the system before installation.
- Do not disassemble the reservoir/pump. Warranty will be voided.
- Perform a leak test before turning on the system.
- Check our website for the latest installation guide.
INSTALLATION
STEP 1 OVERVIEW
The R260 is equipped with multiple ports to allow for more flexibility. Please plan your water loop before proceeding with installation.
- OPTIONAL : PUMP INSTALLATION The D5 pump can be easily deinstalled or installed with the 4x M4 pump screws. Tighten the screws in a diagonal sequence as shown
- Make sure the a-ring is seated correctly and tightened evenly.
- Tighten the pump screws evenly in a diagonal pattern for an even pressure.
- After the screws are tightened, it is normal that there will be small gap between the pump bracket and the acrylic.
STEP 2 FAN BRACKET
- INSTALLATION Mount the 2x Fan Brackets directly to a 120mm or 140mm fan with the 4x Fan Screws.
STEP 3 ALUMINUM COVER INSTALLATION
- Deinstall the aluminum cover from the reservoir and keep the 2x M4x25 screws for STEP 4.
- Mount the aluminum cover on the fan brackets with the 4x M3x8 screws.
- The aluminum cover can be installed Find the correct position and slide the aluminum cover up or down for your setup.
STEP 4 RESERVOIR INSTALLATION
- Secure the reservoir to the aluminum cover with the 2x M4x25 screws.
STEP 5 CONNECT D-RGB LIGHTING
- Connect the D-RGB LED-strip to other Phanteks D-RGB lighting products:
- Optional use the motherboard adapter to connect to the motherboard.
- Daisy chain Phanteks D-RGB products
- *D-RGB Motherboard Cable
STEP 6 POWER ON
- Make sure all connectors and fittings are tightened.
- Connect the pump to a power source.
- Fill the reservoir and let the pump run until all air is released.
NOTE : Let the pump run for multiple hours. Tilting the system & For optimal performance please check the following:
- Make sure the pump never runs dry.
- Close any unused ports with Stop Fittings.
- Always perform a leak test before turning on the system.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>