e thirteen 02072023 Wheel Valve User Manual

e thirteen 02072023 Wheel Valve

IDENTIFY YOUR HUB AND AXLE

INSTRUCTIONS APPLY TO ALL DRIVER CONFIGURATIONS

• PIEDMONT
  

• OPTIMUS, SYLVAN, GRAPPLER EN
  

• GRAPPLER DH

• e*spec
  

REAR HUB W/ALUMINUM AXLE

GREASE
APPLY GREASE AFTER MAINTANENCE

INSTALLATION
PUSH INWARD, ROTATE CLOCKWISE
UNTIL ENDCAP SPINS FREELY.
FOR REMOVEL, ROTATE COUNTER-CLOCKWISE

FRONT HUB (ALL WHEELS)

INSTALLATION

GREASE

REAR HUB W/STEEL AXLE

GREASE

REAR HUB W/STEEL AXLE + PINCH BOLT

GREASE

SHIM + FREEHUB SPACER INSTALLATION

ALL HUBS FOUND ON OPTIMUS, SYLVAN, GRAPPLER AND E*SPEC WHEELS REQUIRED SHIM/FREEHUB SPACER ASSEMBLY AS SHOWN HERE

INSTALLATION
PUSH INWARD, ROTATE CLOCKWISE UNTIL ENDCAP SPINS FREELY*
‘BEFORE INSTALLED ON BIKE, A SMALL AMOUNT OF SIDE-TO-SIDE PLAY IS NORMAL

REMOVAL
PULL OUTWARD, ROTATE COUNTER-CLOCKWISE

INSTALLATION
USING CONE WRENCHES, ROTATE CLOCKWISE UNTIL SNUG, THEN ADD 90°
CONE WRENCH
DRIVE SIDE: 17MM
NON-DRIVE SIDE: 20MM

• some older models of IRS/161 EN use 18mm

REMOVAL
USING CONE WRENCHES, ROTATE COUNTER-CLOCKWISE

INSTALLATION
USING CONE WRENCHES, ROTATE CLOCKWISE UNTIL
SNUG, THEN ADD 90°. TIGHTEN PINCH BOLT TO 3Nm
CONE WRENCH
DRIVE SIDE: 17MM
NON-DRIVE SIDE: 20MM

• ‘some older models of TRS/LGI EN use 18mm

REMOVAL
LOOSEN PINCH BOLT USING CONE WRENCHES, ROTATE ENDCAPS COUNTER-CLOCKWISE

FRONT HUB (ALL WHEELS)

• GREASE
  

• INSTALLATION
  

• REMOVAL
  

TUBELESS TAPE

e*thirteen GEN 2 VALVE

TUBELESS SEALANT + TIRE

CUSTOMER SERVICE

FOR MORE INFORMATION, VISIT SUPPORT.ETHIRTEEN.COM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>