SENOA SNAS-PP Power Point User Guide
- June 12, 2024
- SENOA
Table of Contents
Let’s get connected.
ACCESSIBILITY RANGE
Power Point
Important – Read before installing.
Must only be installed by a LICENSED ELECTRICIAN to local wiring regulations.
Failure to follow these instructions can result in serious injury or death.
Megger testing may lead to low readings due to electronic components so
disconnect all electronic devices before taking a reading. Install the
included warning sticker with circuit detail in the main electrical
switchboard.
AVOID THE RISK OF ELECTRIC SHOCK
Once the product has been fastened to the wall, ensure the screw caps are
inserted firmly into place over the screw mounting holes. (See diagram below)
Using the Power Point.
Connect the wiring.
Surge protection is recommended at the main switchboard. Products damaged by power surges are not covered by warranty.
Part Number:
| White | SNAS-PP |
|---|---|
| Black | SNAS-PPBK |
Line Voltage Frequency:
50Hz Nominal
Rated Load:
Maximum Load 10A @ 250V / 2500W
Pair and setup with Zima.
- Download the Zima App.
- Choose ‘Add Device’.
- Follow the on screen instructions.
Download Zima App.
Point your phone camera at the QR code to open the app store.
Zimi Cloud Connect.
Enjoy the full experience with all your Zima devices.
Internet connection required.
Want to learn more or need help?
Enjoy all the features to make your life easier. Visit our website for tips,
tricks and help. support.zimi.life
| | |
---|---|---|---
Power Lock
Prevent power use at the switch.| Schedules
Turn it on and off any day or time.| Energy Use
Monitor the power usage and cost.| Behavior Link
Control a switch from another switch.
Status Indicator.
| Blue| Ready to pair.
‘Add device’ in Zima to pair and complete setup.
---|---|---
| White| Setup is complete.
This device has been paired and setup completed.
| White pulsing| Action in progress.
This lets you know an automatic function is being activated.
| Blue & White pulsing| Action in progress.
This lets you know an automatic function is being activated.
| Green pulsing| Energy alert.
This shows the device is using high power.
| Red| Device problem.
Please refer to support to resolve the problem.
| Off| Indicator is off.
The status indicator can be turned o and on in settings.
Manufacturer’s Warranty This product has been manufactured to the highest
quality standards. This product is warranted to the original purchaser and is
not transferable. The product is guaranteed to be free from defects in
workmanship and parts for a period of 1 Year from the date of purchase.
Defects that occur within this warranty period, under normal use and care will
be repaired, replaced or refunded. The benefits conferred by this warranty are
in addition to all other rights and remedies of the consumer under a
Commonwealth, State and Territory laws in relation to the goods or services to
which this warranty relates and Australian Consumer Law. Risk in regard to the
product to be repaired shall at all times remain with the Purchaser. The
warranty is given on the condition that the product to which it applies is
used for the purpose and in the manner intended by its construction and for no
other purposes whatsoever. Zima Ltd shall not be responsible for damage of any
kind, caused by accidents, power surges, electrical storm damage, incorrect
power current, infestation (vermin or insect), incorrect installation,
incorrect electricity or plumbing installation, improper use of controls or
failure to use the unit in accordance with the operating instructions, general
misuse or abuse or from normal wear and tear. Any attempt by an Unauthorised
person to repair or tamper with the equipment shall render the warranty null
and void. Goods presented for repair under this warranty may be replaced by
refurbished goods of the same type rather than being repaired. Refurbished
parts may be used to repair the goods. Zima Ltd.’s liability under this
warranty is limited to the replacement and/or repair of the defective parts
within the warranty period and does not extend to installation or removal of
the product. Acceptance of liability by Zima Ltd contained herein is to the
exclusion of any other remedy whatsoever and howsoever arising in respect of
any equipment to which it applies.
Proof of Purchase Please keep your purchase docket or receipt as proof of
purchase and as proof of the date on which the purchase was made. The purchase
docket or receipt must be presented with the warranty when making a claim
under this warranty. Failure to produce documentary proof of the date of
original acquisition by the original Purchaser will result in a charge being
levied for work done, labor and parts supplied. Likewise a charge will be made
for any calls following warranty claim where no fault is found with the unit.
Service during the warranty period The first point of contact for product
issues is the place of purchase. The product must be returned to the original
place of purchase for product repair, replacement or refund. Please ensure the
product is properly packaged so as to ensure that no damage occurs to the
product during transit and make sure that you have included an explanation of
the problem. In the event of goods requiring repair under manufacturer’s
warranty the owner is responsible for the cost of transportation. Should the
goods be found to be in sound working order the owner might be charged a fee.
This warranty is given by Zima Ltd, 14 Millennium Circuit, Helens vale, QLD
4212
Safety Warnings Read all instructions and safety information. All
electrical work must only be undertaken after disconnection of the power by
removing fuses or turning off the circuit breaker, to ensure all pole
disconnection from the electrical supply. All electrical work must be carried
out by a licensed and qualified electrician and in accordance to AS/NZS 3000
Wiring Rules and applicable local authority regulations. This product is not
intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the product
by a person responsible for their safety. Young children should be supervised
to ensure that they do not play with the unit. Do not cut or notch joists,
beams and rafters to install the unit. Do not damage hidden electrical wiring
or utilities when cutting. The product must be installed so that switches and
other controls cannot be touched by a person in the bath or shower. Do not
install the product in a location where water will splash onto it. Check and
confirm that all connections are proper and secure to prevent causing property
damages or injury. Do not install outdoor where it could be exposed to water
or moisture (indoor use only).
Trademarks Zima and SENOA and their respective logos are registered
trademarks of Zima Ltd. Google and Google Play are trademarks of Google LLC.
Amazon, Alexa and all related logos are trademarks of
Amazon.com, Inc. or its affiliates. Apple, the Apple logo,
Apple Watch and iPhone are trademarks of Apple Inc., registered in the U.S.
and other countries. App Store is a service mark of Apple Inc., registered in
the U.S. and other countries.
Copyright © 2022 Zima Ltd. All rights reserved.
14 Millennium Circuit
Helens vale QLD 4212
Australia. www.zimi.life
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>