Rowley RTMDCHCBP High Capacity Battery Pack Owner’s Manual
- June 12, 2024
- Rowley
Table of Contents
High Capacity Battery Pack
RTMDCHCBP
High Capacity Battery Pack – The rechargeable Li-ion Battery Pack enables
DC Tubular Motors to operate wirelessly and without the constraints of
traditional battery wands with disposable batteries.
The small profile allows for optimal placement in the window pocket, fully
recharges in about 6 hours and can be paired with the optional Solar Panel
Battery Charger for continuous recharging.
FEATURES
| | | |
---|---|---|---|---
Up to 500 Up / Down Cycles on Single Charge| Small Profile| Battery Health
Status in R-TEC Automation® App| Recharges in 6 hours| Optional Solar Panel
for Continuous Recharging
SAFETY INSTRUCTIONS
WARNING: Important safety instructions to be read before installation.
Incorrect installation can lead to serious injury and will void manufacturer’s
liability and warranty.
CAUTION
- Do not expose to moisture or extreme temperatures.
- Do not allow children to play with this device.
- Use or modification outside the scope of this instruction manual will void warranty.
- Installation to be performed by a suitably qualified installer.
- For use with DC powered Cord Lift, Tilt and tubular motors.
- Ensure correct crown and drive adaptors are used for the intended system.
- Use only Rollease Acmeda hardware.
- Before installation, remove any unnecessary cords and disable any equipment not needed for powered operation.
- Do not expose the battery to water or install in humid or damp environments.
- Do not drill into battery body.
- The routing of cable through walls shall be protected by isolating bushings or grommets.
- Ensure cables are clear and protected from moving parts.
- Do not use if any cables are damaged
Important safety instructions to be read prior to operation.
- It is important for the safety of persons to follow the enclosed instructions. Save these instructions for future reference.
- Persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge should not be allowed to use this product.
- Keep battery away from acid, alkali, heat & fire.
Do not dispose of in general waste.
Please recycle batteries and damaged electrical products appropriately.
SPECIFICATIONS
| Input Volts | 12.6V |
|---|---|
| Output Volts | 12.0V |
| Capacity | 2600mAh |
| Insulation Class | III |
| Battery Size/Type | 1-1/4” x 1-1/4” x 10” / Lithium-ion Rechargable |
| Temperature Working Range | 32°F to 140°F (0°C to 60°C) |
INSTALLATION
1.1 Charging
Charging uses the 2 pin locking “SMR” style connector.
IMPORTANT
Rechargeable Battery Pack must be fully charged prior to first use to prolong
battery lifespan.
Step 1. Connect the Rechargeable Battery Pack to the Battery Charger.
RTMDC18/25
Step 2. Charge for 6 hours.
Step 3. Install as required.
Charging Cable
1.2 Attachment Methods
|
| 
---|---|---
Hook| Screw| **Double Sided Tape***
IMPORTANT
Do not install Rechargeable Battery Pack where it will be exposed to direct
sun light.
1.3 Motor Connections
Charging uses the 2 pin, non-locking “JST” style connector.
Any Questions?
Contact our R-TEC Automation®
in-house experts at 866.985.3423.
Email us at
RTECAutomation@RowleyCompany.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>