R TEC AUTOMATION by Rowley High Capacity Battery Pack User Manual

R TEC AUTOMATION by Rowley High Capacity Battery Pack

FEATURES

COMPLIANCE STATEMENT

This device complies with the essential requirements and is tested to comply with:

•  UN38.3 – UN Transport Test and Criteria for Lithium Batteries.
• UL 2595, CSA C22.2 No. 0.23 – General Requirements for Battery-powered Appliances.

Testing is conducted to cover all aspects of the UN Model Regulations, Manual of Test and Criteria, Part III, subsection 38.3, including

• Altitude Simulation
• Thermal Test
• Vibration
• Shock
• External Short Circuit
• Impact / Crush
• Overcharge
• Forced Discharge

Additionally, all battery product assemblies utilize an integrated charge management circuit that protects against over or under-charging. This circuit also enables individual cell balancing which ensures the longevity and integrity of the entire battery pack.

TECHNICAL DATA / PACK CONTENTS

PRODUCT SPECIFICATIONS

SAFETY

WARNING
Incorrect installation can lead to serious injury and will void the manufacturer’s liability and warranty.

CAUTION

• Do not expose to moisture or extreme temperatures.
• Do not allow children to play with this device.
• Use or modification outside the scope of this instruction manual will void the warranty.
• Installation and programming to be performed by a suitably qualified installer.
• For use within DC Tubular Motors.
• Ensure correct crown and drive adaptors are used for the intended system.
• Do not cut power cables.
• Use only R-TEC Automation® hardware.
• Before installation, remove any unnecessary cords and disable any equipment not needed for powered operation.
• Do not drill into the battery body.
• The routing of cable through walls shall be protected by isolating bushes or grommets.
• Ensure the power cable is clear and protected from moving parts.
• If any cables are damaged, do not use them.

IMPORTANT SAFETY INSTRUCTIONS TO BE READ PRIOR TO OPERATION

• It is important for the safety of persons to follow the enclosed instructions. Save these instructions for future reference.

• Persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge
  should not be allowed to use this product.

• Keep the battery away from acid, alkali, heat, and fire.

Do not dispose of general waste.
Please recycle batteries and damaged electrical products appropriately.

INSTALLATION

CHARGING

Charging uses the 2 pin locking “SMR” style connector.

IMPORTANT

Rechargeable Battery Pack must be fully charged prior to first use to prolong battery lifespan.

(1) Connect the High Capacity Battery Pack to the Battery Charger RTMLBC or optional Solar Panel Battery Charger RTMSOLAR2.
(2) Charge for 6 hours.
(3) Install as required. See below attachment methods.

ATTACHMENT METHODS

IMPORTANT
Do not install Rechargeable Battery Pack where it will be exposed to direct sunlight.

MOTOR CONNECTIONS

SCENARIO EXAMPLE USING SOLAR PANEL Y CABLE

DIMENSIONS

Mounting the Battery Pack to the Dustboard

*Power Cords plug into each other from the Motor to the Battery Pack. Keep cords away from rotating parts of the shade during operation.

Any Questions?
Contact our R-TEC Automation® in-house experts at 866.985.3423. Email us at RTECAutomation@RowleyCompany.com.

© 2021 Rowley® Company. All rights reserved. R-TEC Automation® is a registered trademark of the Rowley® Company, LLC.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>