BLING LIGHTING E27 RGB 16 Multi Color Changing Light Bulb with Remote Control Instruction Manual
- June 12, 2024
- BLING LIGHTING
Table of Contents
BLING LIGHTING E27 RGB 16 Multi Color Changing Light Bulb with Remote
Control Instruction Manual
Use Tips for the Remote Control
Check if the remote works:
Install the battery (not included) to the remote. Switch on the lamp and check if every button works well.
If the remote control doesn’t work for the lamp, please check whether the indicator light lights up or not. If it is on, please match the code (refer to “Matching Process”).
If it still doesn’t work, please clear the code (refer to “Code-clearing Process”) and match the code again. Or please contact us immediately.
Matching Process:
-
Install the lamp and turn it on.
-
Within 1 minute of power-on, press the power button of the remote and hold on around 3 seconds.
-
When the light flashes, it matches successfully.
Code-clearing Process:
Switch on and off for 5 cycles. When the lamp flashes, it means clear the code
successfully.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. RF Exposure
Information
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>