Shenzhen Bling Lighting Technologies YL.BQ.1348 UFO Floor Lamp Instructions
- June 6, 2024
- Shenzhen Bling Lighting Technologies
Table of Contents
Remote Controller Instruction
- The remote controller requires 2 AAA batteries (Not included).
- The scheduled timing cannot be accumulated. Turn off the Power Button and the timer setting will be canceled.
| Button | Function |
|---|---|
| Power Button | Turn ON/OFF all the lights |
| Night mode | Night light mode |
Up Lights
Power Button| Turn ON/OFF the Up Lights
Up lights CCT-| Short touch: Cool white to Warm white by steps
Long touch: Cool white to Warm white smoothly
Up lights CCT+| Short touch: Warm white to Daylight by steps
Long touch: Warm white to Daylight smoothly
Up Lights Brightness+| Short touch: Dim Up Lights brighter by steps
Long touch: Dim Up Lights brighter smoothly
Up Lights Brightness –| Short touch: Dim down Up Lights by steps
Long touch: Dim down Up Lights by smoothly
Ring Lights
Power Button| Turn ON/OFF the Ring lights
Ring Lights Mode| Short touch: Browse previous Ring lights modes
Long touch: N/A
Ring Lights Mode| Short touch: Browse later Ring lights modes
Long touch: N/A
Ring Lights
Brightness+/Speed+| Short touch:Increase the Brightness or Speed by Steps
Long touch: Increase the Brightness or Speed Smoothly
Button| Function
---|---
Ring Lights
Brightness-/Speed-| Short touch:Decrease the Brightness or Speed by Steps
Long touch: Decrease the Brightness or Speed Smoothly
1H 1H Timer Setting| Lights turn off automatically in 1 hour
2H 2H Timer Setting| Lights turn off automatically in 2 hours
3H 3H Timer Setting| Lights turn off automatically in 3 hours
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>