Shark NV600 Series Rotator Lift-Away Speed FAQs
- June 9, 2024
- Shark
Table of Contents
Shark NV600 Series Rotator Lift-Away Speed FAQs
This article contains the FAQs for the NV600 Series Shark® Rotator® Lift-Away Speed™. This supports the following SKUs NV600, NV601 and NV602.
FAQs
General questions about using the vacuum:
How do I assemble my vacuum?
Place the pod onto floor nozzle.
Slide wand into base of pod.
Insert handle into top of wand. Then attach hose to hose connector on base of pod.
Insert tools into accessory holder, then secure the hose to the hose clip by pushing the knob into its socket.
How do I remove the handle to clean “above floors”?
Push handle latch down, then lift the handle up off of the wand.
How do I remove the handle with extension wand to clean “above floors”?
Press Wand Release button on pod when you need to clean with a longer reach.
How do I detach the Pod for portable cleaning?
Press Lift-Away to lift pod off floor nozzle.
General questions about maintenance:
How do I clean the filters and how often?
For optimal performance, it is recommended to clean filters regularly. Between washings, your filter can be tapped clean to remove any excess dust and other particles into the trash.
Pre-Motor Foam and Felt Filter: Under normal usage, rinse and let air dry completely (for 24 hours) every 3 months. With the dust cup removed, take out the foam and felt filters. Rinse the filters thoroughly in lukewarm water until the water runs clear. Squeeze out excess water and let air-dry completely for at least 24 hours before replacing. Do not place filters in the dishwasher or washing machine. To replace back in the vacuum once dry, put the felt filter in first, then add the foam filter.
Post-Motor HEPA filter: Under normal usage, rinse and air-dry once every 12 months or as needed. To access the HEPA filter, press the button on top of the grill, and pull the grill away from the vacuum. Remove and rinse the HEPA filter. Allow the filter to air dry completely for 24 hours. Once the HEPA filter is dry, replace it back into the vacuum, and then replace the cover by lining up the tabs on one side and swinging the door securely closed until it clicks into place.
How do I empty the dust cup and how often?
Lift the dust cup off the pod by pulling up on the release latches on the sides of the dust cup handle. Hold dust cup over a trash bin and press the bottom dust-cup release latch. Press top dust-cup release latch to access dust screen and remove built-up debris as required.
How do I maintain the brushroll?
Press Brushroll Garage buttons to pop up the garage door.
Lift the brushroll out by the tab on the left side.
Remove any string, hair or debris that may be wrapped around the brushroll.
Product Specifications:
Where is the product made?
Our products are manufactured by our high-quality vacuum manufacturing partners in China
What is the weight of the vacuum?
14.3 lbs
What are the dimensions of the vacuum?
12″ L x 11.4″ W x 46.5″ H
What is the dirt capacity of the dust cup?
0.9 dry quarts
What is the length of the cord?
The cord is 25 feet long
What is the Voltage?
120 Volts
What is the Wattage?
900 Watts
What is the Amperage?
7.5 Amps
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>