Inspire 36304897 Villar 106cm Ceiling Fan with Light Instruction Manual
- June 12, 2024
- iNSPIRE
Table of Contents
Villar
EAN CODE : 3276007345384
Assembly – Use – Maintenance Manual
OR42301
Original Instructions
NO:1261C
2023/01-V01
Legal & Safety Instructions
Assembly
Use
1. WARNING SYMBOLS
| Read the instructions carefully.
---|---
| Lamp
| Protective Earth
2. GENERAL SAFETY INSTRUCTIONS
Read this instruction manual thoroughly before using the appliance and save it
for future reference and if necessary pass the instruction manual on to a
third party.
WARNING: When using electrical appliance, basic safety precautions should
always be followed to reduce the risk of fire, electrical shock and personal
injury.
WARNING: If unusual oscillating movement is observed, immediately stop
using the ceiling fan and contact the manufacturer, its service agent or
suitably qualified persons.
1) General
Check if the electrical specifications of the appliance are compatible with
your installation.
Unauthorized use or technical modification to the appliance can lead to danger
to life and health.
This appliance is not intended for use by persons(including children)with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
This appliance is for indoor use only except moist or wet room.
Means for disconnection must be incorporated in the fixed wiring in accordance
with wiring rules into force.
Before pushing the reversible slide switch, it is necessary to stop the action
of the blades by turning off the fan.
The supplier disclaims all liability for personal injury or property damage
arising from incorrect use or installation of the fan. In doubt, call upon an
electrician.
Children should be supervised to ensure that they do not play with the
appliance.
Be careful when working near the rotating blades.
Warning: only to be installed outside arms reach.
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
2) Electrical Safety
The product should be installed by an authorized electrician in accordance to
national wiring rules.
The replacement of parts of the safety suspension system device shall be
performed by the manufacturer, its service agent or suitably qualified
persons.
The mounting of the suspension system shall be performed by the manufacturer,
its service agent or suitably qualified persons.
An all-pole disconnector with isolating distance of 3mm must be incorporated
in the fixed wiring in accordance with the national wiring rules.
This product is in accordance with safety standards into force. Repairs should
be exclusively performed by qualified technicians using original spare parts.
Any breach of this instruction may be particularly dangerous for the users.
3. SPECIFIC SAFETY RULES
The fan base mounting bracket can support a load of 28 kgs.
The fan is to installed so that the blades are more than 2,3m above the floor
and the blades distance to wall min 0.6m.
4. ENVIRONMENTAL PROTECTION
CAUTION!
Electrical products must not be thrown out with domestic waste. They must be
taken to a communal collecting point for environmentally friendly disposal in
accordance with local regulations. Contact your local authorities or stockiest
for advice on recycling.
The packaging material is recyclable. Dispose of the packaging in an
environmentally friendly manner and make it available for the recyclable
material collection-service.
5. APPLIANCE SPECIFICATIONS
TECHNICAL CHARACTERISTICS
Rated voltage| 220V-240V~
Rated frequency| 50Hz
Operating Frequency| 433,92 MHz
Transmit power| Max. -9 dBm
Fan rated wattage| 23W
Fan power input| 20.7W
Bulb type| 18W
Protection| class I
IP number| IP 20 (Only for light)
Weight| 5.6 kg
Maximum fan flow rate| 105.0 m³/min
Service value| 4.9 (m³/min)/W
Fan sound power level| Max. 54 dB(A)
Supply current| 0.26A
Power factor| 0.412
Standby power consumption| 0.4W
Maximum air velocity| 2.1 meters/sec
Measurement standard for service value| 2009/125/EC, (EU) NO 206/2012+(EU) NO
2016/2282, EN 60879:2019, EN 60704-1:2010+A11:2012, EN 60704-2-7:1998
This product contains a light source of energy efficiency class
6. MAINTENANCE / CLEANING
Always disconnect the appliance before cleaning or doing maintenance.
Never use a wet sponge to clean the appliance.
In order to not damage the product, it is advisable to use adapted equipment
to the fragile surfaces and products slowing the wear on the appliance.
7. REPAIR GUIDE
| TROUBLE | PROBABLE CAUSE | SUGGEST REMEDY |
|---|---|---|
| Fan will not start |
- The fan is under protection.
- Fuse or circuit breaker blown.
- Loose power line connections to the fan.
- Speed controller not in correct position.
|
- Restart the fan after 10 seconds without power.
- Check main and branch circuit fuses or circuit breakers.
- Check line wire connections to fan and wires.
- Check speed controller’s position.
Fan sounds noisy|
- Top canopy touching ceiling.
- Loose fan blades screws.
- Ceiling fan not secured against ceiling.
- Incorrect speed controller.
|
- Lower canopy form ceiling to ensure minimum 3mm clearance.
- Re-tighten all screws on fan blades but never over-tighten.
- Re-tighten all screws in the hanging bracket or plate.
- Change the controller to one supplied.
Mechanical noise| | Allow at least for 8 hours setting-in period.
Fan wobbles|
- Fan blades are not horizontal to ceiling.
- Blade screws are loose.
|
- Measure from ceiling to tips of blades, then rotate fan so all blades are checked for equal height from ceiling(not adjustments may be made by slight pressure up or down on blade holders).
- Make sure all screws are securely fastened.
8. GUARANTEE
1. WARRANTY DURATION:
The general legal warranty applies in accordance with the statutory provisions
in force in your country from the delivery of the goods and upon providing the
receipt as the proof of the purchase.
However, INSPIRE goes beyond that. We want you to have the best experience
possible with our products, thus we have extended the warranty periods for all
INSPIRE products to 8 years.
2. WARRANTY APPLICATION:
For the warranty to be applied, the product must have been installed, used and
maintained according to the Instruction Manual guidelines.
3. QUESTIONS AND CLAIMS:
If you have any questions or encounter any problems regarding the use of the
product, its performance or visual aspect, you are welcome to contact your
vendor through the contact information you will find on the purchasing
receipt.
9. OTHERS (SERVICE, REPAIRING, ETC.)
Have your product repaired by a qualified person.
This electric product is in accordance with the relevant safety requirements.
Repairs should only be carried out by qualified persons using original spare
parts, otherwise this may result in considerable danger to the user.
Please contact the store which you bought the product for after sale services
if any question.
Please contact the store which you bought the product if you lost the
installation manual.
The light source contained in this luminaire shall only be replaced by the
manufacturer or his service agent or a similar qualified person.
When environmental relative humidity is above 90%,blades have to be slightly
bended after 5 years.
EU/EC Declaration of conformity
Product Model
819217/819219/819211/819218/819226/819223/819229/811115
Name and address of the manufacturer or his authorised representative
ADEO Services, 135 Rue Sadi Carnot – CS 00001 59790 RONCHIN – France
This declaration of conformity is issued under the sole responsibility of the manufacturer
Object of the declaration
Product Type – Description| C.FAN 122CM LED 2200LM CCTDIM MET.NICKEL+PC
DARK DCMOT INSP VADILLO
C.FAN 122CM LED 2200LM CCTDIM MET.WHITE+PC CLEAR WOOD DCMOT INSP
CALPE
C.FAN 132CM LED2200LM CCTDIM MET.CHROME+PLAST.GREY DCMOT INSP GANDIA
C.FAN 132CM LED 2200LM CCTDIM MET.WHITE+PLASTIC BROWN DCMOT INSP
WILMA
C.FAN 112CM LED 2200LM CCTDIM METAL WHITE + WOOD WHITE INSPIRE TIVANO
C.FAN 132CM LED 2200LM CCTDIM METAL WH + WOOD WH DCMOT INSP TIVANO L
C.FAN 106CM LED 2200LM CCTDIM MET.ANTIQUE BRASS+DARKWOOD DCMOT INSP
VILLAR
CF LED 107CM2200LM CCTDIMM PLASTIC WOOD EFFECT DC MOTORINSP CHERCH
Product Reference| 819217/819219/819211/819218/819226/819223/819229/811115
– EAN Code:
3276007345445/3276007345377/3276007345353/3276007345414/3276007345278/
3276007345346/3276007345384/3276007496857
Industrial Type Design Reference:
PD48301/MB48401/PN52301A(G)/PN52301A(W)/JG44A-3-1LA/JG52A-3-
1LA/OR42301/SH42301
Product Brand| Inspire
Serial number coding or batch number| SSSSSSDDMMYYYY(SSSSSS means the
supplier code; DDMMYYYY means the ETD date)
The object of the declaration described above is in conformity with the
relevant Union harmonization legislation| References to the relevant
harmonised standards used or references to the specifications in relation to
which conformity is declared| When applicable, the name and number of notified
body number
2014_53_EU_RED
radio equipment| EN 300 220-2 V3.1.1:2017-02
EN 300 328 V2.2.2:2019-07
EN 301 489-1 V2.2.3:2019-11
EN 301 489-3 V2.1.1:2019-03
EN 301 489-17 V3.2.4:2020-09
EN 55014-1:2017+A11:2020
EN IEC 55014-1:2021
EN 55014-2: 2015
EN IEC 55014-2:2021
EN IEC 61000-3-2:2019+A1:2021
EN 61000-3-3:2013+A1:2019+A2:2021
EN 50665:2017
EN 50663:2017
EN 60335-
1:2012+A11:2014+A13:2017+A14:2019+A1:2019+A2:2019+A15:2021
EN 60335-2-80:2003+A1:2004+A2:2009
EN 62233:2008
EN IEC 60598-1:2021+A11:2022
EN IEC 60598-2-1:2021
EN 62493:2015
IEC TR 62778:2014|
2011_65_EU_RoHS
Restriction of hazardous substances in electrical products|
(EU)2015/863 amending Directive 2011/65/EU
IEC 62321-3-1:2013
IEC 62321-4:2013+A1:2017
IEC 62321-5:2013
IEC 62321-6:2015
IEC 62321-7-1:2015
IEC 62321-7-2:2017
IEC 62321-8:2017
EN IEC 63000:2018|
2009_125 ECO DESIGN
EcoDesign| (EU) No.206/2012
(EU) No 2016/2282
(EU) 2019/2020
(EU) 2021/341
(EU) 2019/2015
(EU) 2021/340|
Compiled, signed by and on behalf of| Eric LEMOINE
International Project Quality Leader|
Place and date of issue| Ronchin France
27/09/2022
1
2
*Use screws and dowels suited to your backing.
3
L = Brown
N = Blue
= Green
4
5
6
7
8
9
10
11
12
1
2
3
4
5
6
7
8
9.a
9.b
For the first use, the fan and the remote control are already paired. Pair setting may occur in following situations:
- You would like to use one remote control to control more than one fan.
- You get a new wireless remote control spare part.
1. Turn on power supply switch.
2-1. Long press the “ ” key within 10 seconds.
2-2. If the fan makes a “bip” sound, means the fan is paired successfully.
(If the fan pairing fails, please try again after 10 seconds of shutting down
the power.)
SPARE PARTS
Some parts of this product can be ordered from your store
*8-year guarantee
Made in China 2023
ADEO Services – 135 Rue Sadi Carnot – CS 00001
59790 RONCHIN – France
