Rhine 7262T6 Ceiling Fan Controller Instruction Manual
- June 12, 2024
- Rhine
Table of Contents
Rhine 7262T6 Ceiling Fan Controller
INSTRUCTIONS FOR OPERATION
SETING THE OPERATING CONTROLS
-
This unit operates on AAA*2PCS.; 3 volts battery (not included).
To prevent possible damage if the battery should leak, be sure to remove the battery when the unit is not use.
Store the controller away from excess heat or humidity. -
This remote-control unit is required with 35bit code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system.
-
Operation buttons on the panel of transmitter.
| key – For FAN and LIGHT ON/OFF control .
---|---
| key – For LIGHT ON/OFF control .
| key – For Dimming – brightening
key – For Dimming – dimming
| key – For UC7262T6 Light color temperature Adjustment,UC7262T6A not
available
| key – For FAN ON/OFF control .
| key –For Fan speed up control .
key –For Fan slow down control .
| key –For fan natural wind speed control .
| Key –For fan blowing up control .
| key –For fan blowing down control .
| Key – Close Fan after 2 hours
| Key – Close Fan after 4 hours
| Key – Close Fan after 8 hours
| Key – fan learning
GENERAL INFORMATION :
This remote controller is designed to separately control your ceiling fan
speed and light brightness.
INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER Setup for
ceiling fan controller
- Turn off the power. (In order to make sure the electricity is entirely released, please press any button on the controller till no LED display showing)
- Turn on the power
- Press the FAN OFF button for more than 3 sec. The ceiling fan controller will have 2 blinks. It means the setup is successful. You could start to control the ceiling fan light and fan speed.
NOTICE:
The changes or modifications not expressly approved by the party responsible
for compliance could void user’s authority to operate the equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this
device could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
Canada, Industry Canada (IC) Notices
Operation is Operation is subject subject subject to the following following following two conditions: conditions: conditions: (1) this device may not cause interference, and interference, and (2) this device must accept any interference, interference, interference, including including including interference interference that may that may cause undesired undesired undesired operation operation operation of the device. device. Canada, Avis Canada, Avis’s industry s industry industry Canada (IC)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>