RHINE ELECTRONICS G-TX751 Garage Door Openers Instruction Manual
- August 30, 2024
- RHINE ELECTRONICS
Table of Contents
RHINE ELECTRONICS G-TX751 Garage Door Openers
SETTING THE OPERATING CONTROLS
-
This unit operates on CR2032*1 PCS; 3 volts battery (not included).
To prevent possible damage if the battery should leak, be sure to remove the battery when the unit is not use. -
Store the controller away from excess heat or humidity.
-
This remote-control unit is required with 66bit code hopping technology. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system.
-
Operation buttons on the panel of transmitter.
| 1| key – For Up Door
---|---|---
2| key – For Stop Door
3| key –For Down Door
| |
- Use CR2032 3V battery
- Replace the battery: Use a screwdriver counterclockwise, remove the screws on the back, open the rear case, take out the old battery and put in a new one. After installing the battery, put back the rear case and lock the rear case clockwise with a tool to complete the battery replacement.
Warning slogans engraved on the back of the shell:
WARNING Chemical Burn Hazard. Keep batteries away From children. See Manual.
GENERAL INFORMATION
This remote controller is designed to separately control your Garage Door Openers.
NOTICE:
The changes or modifications not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment.
IMPORTANT NOTE:
To comply with the FCC RF exposure compliance requirements, no change to the
antenna or the device is permitted.
Any change to the antenna or the device could result in the device exceeding
the RF exposure requirements and void user’s authority to operate the device.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause
Canada, Industry Canada (IC) Notices
This device complies with Canada license‐exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Canada, Avis’s industry Canada (IC)
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry Canada
(IC) radio frequency exposure limits. The Wireless Device should be used in
such a manner such that the potential for human contact during normal
operation is minimized.
This device has also been evaluated and shown compliant with the IC RF
Exposure limits under portable exposure conditions.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>