CRYSTORAMA ALI-B2008-CZ Alister Eight Light Chandelier Instruction Manual

CRYSTORAMA ALI-B2008-CZ Alister Eight Light Chandelier

Product Information

The CRYST RAMA is a ceiling light fixture designed for hanging and can be used to change bulbs easily. It is an electrical device that requires caution when handling to avoid electrical danger. The product is listed and has a part number for identification purposes.

Product Usage Instructions

Installation
To install the CRYST RAMA, please follow these steps:

1. Turn off the power to the electrical circuit where the fixture will be installed. This is important to ensure safety during installation.
2. Identify a suitable location on the ceiling for the fixture.
3. Securely mount the fixture using the provided hardware and following the manufacturer’s instructions.
4. Connect the electrical wiring of the fixture to the corresponding wires in the electrical circuit, following proper electrical wiring procedures.
5. Once the wiring is securely connected, restore power to the electrical circuit.

Changing Bulb
To change the bulb in the CRYST RAMA, please follow these steps:

1. Turn off the power to the electrical circuit where the fixture is installed.
2. Remove any decorative elements or coverings from the fixture, if applicable.
3. Gently twist or unscrew the existing bulb counterclockwise to remove it from the socket.
4. Insert a new compatible bulb into the socket and gently twist or screw it clockwise until it is securely in place.
5. Replace any decorative elements or coverings that were removed.
6. Restore power to the electrical circuit.

It is important to always follow proper safety precautions and consult the user manual for specific instructions related to your particular model of CRYST RAMA.

ASSEMBLY INSTRUCTION

MODEL #ALI-B2008-CZ

All electrical must be installed by a licensed electrician in accordance with the Notional Electric Code and the appropriate local electrical codes, You Will need — Can d. aulb 40 Watts Recommended 60 Watts Mox
USE LED BULBS FOR EXTENDED USE
This fixture is DAMP rated

How to Install

Hanging

1. Pass the fixture wire through one of long rods and attach it onto the top wire box and secure it with nuts.
2. .Attach the rest 2 long rods onto the wire box and secure with nuts-
3. Pass the fixture wires through the hickey inside the wire box and then through the top plate and loop.
4. Secure the top plate With loop.
5. Hook the long rods onto the fixture ring.
6. Refer to figure 1 for canopy , wiring installation.
7. Take the cover plate on the fixture ring off by removing the screws.
8. .Pass the crystal pin through the crystal bar and raise it up and let the pin pass through the small tubing inside the ring. Then bend the pin over to secure the crystal.See illustration.
9. 1nstall the bulb and put the cover plate back and secure it with screws.

How to Install: Ceiling Mount

1. Same crystal installation step as the hanging.
2. Remove the loop of the long rod and install them on the short rod.
3. pass the fixture Wire through one Of short rods and attach it onto the top wire box and secure it with nuts.
4. Attach the remaining short rods onto the wire box and secure with nuts.
5. .install the frame onto the outlet box and secure it with finial.

Changing bulb
Gently spread two crystals bars apart, to access the bulb sockets.

WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm. For more information go to www.P65Warnings.ca.gov

PART NUMBER

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>