SEALEY LED1R LED Vehicle Mounted Work Lights Owner’s Manual
- June 12, 2024
- SEALEY
Table of Contents
SEALEY LED1R LED Vehicle Mounted Work Lights Owner’s Manual
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instructions
SAFETY
ELECTRICAL SAFETY
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following: You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets and any other connectors for wear or damage.
Ensure that cables are always protected against short circuit and overload.
Regularly inspect power supply cables check all connections to ensure that
none are loose.
IMPORTANT: Ensure that the voltage marked on the appliance matches the
power supply to be used and that the circuit is fitted with the
correct fuse. If in doubt, consult a qualified technician to connect the
floodlight to a fused and switched DC supply.
- DO NOT pull or carry the floodlight by the power cable.
- DO NOT use worn or damaged cables, plugs or connectors.
- Immediately have any faulty item repaired or replaced by a qualified technician.
INTRODUCTION
MODEL NO. LED1R
4 x 3W Epistar™ high power LEDs. Produces up to 960 lumens output. Operating
voltage of 10-30V DC. Waterproof rating of IP68.
ECE R10 Certified and E-Marked. Suitable replacement for traditional halogen
work lights. Powder coated die-cast aluminium housing.
Adjustable grade 201 shock-resistant stainless steel bracket.
MODEL NO. LED3R
9 x 3W Epistar™ high power LEDs. Produces up to 2160 lumens output. Operating
voltage of 10-30V DC. Waterproof rating of IP68. ECE R10 Certified and
E-Marked. Suitable replacement for traditional halogen work lights. Powder
coated die-cast aluminium housing. Adjustable grade 201 shock-resistant
stainless steel bracket.
MODEL NO. LED3RM
9 x 3W Epistar™ high power LEDs. Produces up to 2160 lumens output. Operating
voltage of 10-30V DC. Waterproof rating of IP68. ECE R10 Certified and
E-Marked. Suitable replacement for traditional halogen worklights. Powder
coated die-cast aluminium housing. Adjustable grade 304 shock-resistant
stainless steel bracket. Supplied with a magnetic base, coiled cable and
vehicle accessory socket plug.
MODEL NO. LED4R
14 x 3w Epistar™ high power LEDs. produces up to 3360 lumens output. Operating
voltage of 10-30V DC. Waterproof rating of IP68.
ECE R10 Certified and E-marked. Suitable replacement for traditional halogen
work lights. Powder coated die-cast aluminium housing. Adjustable grade 201
shock-resistant stainless steel bracket.
SPECIFICATION
MODEL NO:…………..LED1R……………….LED3R……………….LED3RM…………….LED4R
Lumen Output:
960lm……………………………..2160lm………………………………..2160lm………………………….3360lm
Power: …………12W……………………………………27W…………………………………….27W………………………………42W
Supply: ………… 10-30VDC……………………..10-30V DC……………………………10-30V
DC…………………….10-30V DC
Size (W x H):……. Ø80mm……………..Ø115mm…………………..Ø115mm………………………..Ø115mm
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations.
Note: It is our policy to continually improve products and as such we
reserve the right to alter data, specifications and component parts without
prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is
required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
