OLIGHT Javelot Turbo User Manual

USER MANUAL

Thank you for purchasing this Olight product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

SPECIFICATIONS

All performance measurements in accordance with ANSI/NEMA FL1-2009 standards.
Stated data were been measured indoor under 25 degrees celsius, windless laboratory conditions. The data may vary due to environmental and heat dissipation conditions.

USB MAGNETIC CHARGING CABLE — MCC3

Green: full (over 95%) or disconnected with flashlight
Time to fully charge| 10 hours

PRODUCT OVERVIEW

BEFORE FIRST USE

Please remove the protective film on the lens, and please also unscrew the body to remove the insulating film within the battery compartment, then screw the body back on tightly.

BATTERY LEVEL INDICATOR

CHARGING

• Before first use please fully charge the product.
• Connect the USB end of the magnetic charging cable to an external USB power source, then attach the other end of the cable to the magnetic charging port of the light. It takes no more than 10 hours  to fully charge the light (For reference only. When the USB power source is insufficient to provide 5V 2A power capacity, the charging time will be longer). The red indicator means charging, while the green indicator means charging completed (battery level ＞95%).
• Only charge with standard MCC3. NOT compatible with other MCC.

DANGER

• DO NOT shine the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
• DO NOT cover the light head when the light is on, or place the light head on the ground. The radiation energy of the light may cause damage to the light itself, or even result in burning to flammable objects.
• DO NOT store the flashlight when its surface is under high temperature.
• When the flashlight is working on the turbo mode, the surface temperature can reach 55°C. At that time, DO NOT touch the hot surface of the head.

WARNING

• Keep out of reach of children.
• DO NOT use the turbo mode continuously when the environmental temperature is high in case the flashlight body is too hot to hold.
• DO NOT short-circuit the switch cap with the ring surrounding it in any manner, including placing it in your mouth or licking it with your tongue.

NOTICE

• The tail of the flashlight is magnetic. If iron powder or other metallic conductors are attracted to it. Please remove them as soon as possible to avoid electricity leakage.
• The surface of the flashlight may reach up to 55°C when the highest brightness setting is used for about 4.5 minutes, and then the output will decrease gradually to ensure safety. However, it will never be less than 800 lumens, unless the battery is too low.
• The highest brightness will be capped at 500 lumens when the ambient temperature is below zero. To restore it to the normal level, please preheat the flashlight.

Hazard Hot surface
Human behavior that is intended to be caused after understanding the safety sign’s meaning. Taking care to avoid coming into contact with a hot surface.

HOW TO OPERATE

TAIL SWITCH
Constant Low Mode: Quickly half-press the tail switch to produce a low light output (15 lumens) or turn the light off (if already on).
Momentary Low Mode: Half-press and hold the tail switch to enter Momentary on mode and release the tail switch to exit the mode.
Constant Turbo Mode: Quickly full-press the tail switch to enter Turbo (1300 lumens) or turn the light off (if already on). To exit turbo mode, full- press the tail switch again.
Momentary Turbo Mode: Full-press and hold down the switch to enter Momentary Turbo on mode. Release the switch to exit turbo mode.

SIDE SWITCH
Press and hold the side switch to turn the flashlight on or off. When turning on, the brightness level is memorized as the last output selected when the light was turned off via the side switch.
When turning on, single click the side switch to change modes. Single click the side switch to cycle through the brightness levels. Starting from the present brightness, the output brightness will enter the next high brightness according to the preset order.
When the output is in Turbo, single click the side switch to enter the low mode (15 lumens).

EU-DECLARATION OF CONFORMITY

EU-Declaration of Conformity can be found here: https://olightworld.com/ec- declaration

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery Pack: 2 years.
MCC Magnetic USB Charging Cable: 1 year.

This warranty does not cover normal wear and tear, modifications, misuse, disintegrations, negligence, accidents, improper maintenance, or repair by anyone other than an authorized retailer or Olight itself.

USA Customer Support
cs@olightstore.com
Global Customer Support
customer-service@olightworld.com
Visit www.olightworld.com to see our complete
product line of portable illumination tools.

Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan
Town, Dongguan City, Guangdong, China.
Made in China
3.0047.6010.9002
A. 11, 04, 2020

www.DrMemory.com/Olight

References

• Olight Manual & Datasheet Library
• Olight | Illuminate Your World.
• Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>