EKVIP 022495 Christmas Tree Instruction Manual
- June 12, 2024
- EKVIP
Table of Contents
EKVIP 022495 Christmas Tree Instruction Manual
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for
future reference.
(Translation of the original instructions).
SAFETY INSTRUCTIONS
- Do not connect the product to a power point while the product is still in the pack.
- Only intended to be used indoors.
- that no light sources are damaged.
- Do not connect two or more products together to a power source.
- No parts of the product can be replaced, or repaired. The whole product must be discarded if any part is damaged.
- Do not use sharp or pointed objects during assembly.
- Do not subject the power cord or wires to mechanical stress.
- This is not a toy. Be careful if using the product near children.
- Disconnect the transformer from the power point when the product is not in use.
- The product is not intended to be used as general lighting.
- Recycle products that have reached the end of their useful life according to local regulations.
WARNING!
The product must only be used when all the seals are correctly fitted.
TECHNICAL DATA
Rated voltage 230 V ~ 50 Hz
Output 3,6 W
No. of LEDs 200
Protection rating IP20
ASSEMBLY
-
Remove the parts from the packaging.
-
Angle out the foot of the Christmas tree so that it is at 90° between the four feet. Put the bottom pole (1) in the foot.
-
Put the top pole (2) in the bottom (1).
-
Put the bottom part of the tree on the pole.
-
Fold out the branches
-
Put the top part of the tree over the bottom. Connect the contact parts together.
-
Place the tree in the required place and plug the plug into a power point.
Read More About This Manual & Download PDF: