Maxax F66-WD New York 65 Inch Wood Grain and Black Metal Floor Lamp Instruction Manual
- June 12, 2024
- Maxax
Table of Contents
Maxax F66-WD New York 65 Inch Wood Grain and Black Metal Floor Lamp
Product Information
Dear Customer:
Thank you for your business! If you have any question or problem, please send
us an email to support@4modernhome.com or
call us at 870-949-8466. We will do
everything possible to make you completely satisfied with your purchase.
Product reviews help future customers to make their purchase decision. You are
encouraged to share your experience by leaving a short product review on the
platform where you bought this product.
Thank you!
Zgear Team
- Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure full compliance with N.E.C. requirements If there are any questions, contact a qualified electric contractor.
- Warning: California Residents Proposition 65 This product contains lead, a chemical known to the state of California to cause cancer and birth defects or other reproductive harm. Do not place the product in your mouth. Wash your hands after handling this product.
- Caution: It is highly recommended to get an electrician to install this light. Please make sure to turn the electricity off at the main circuit breaker before beginning installation. All glass is fragile. Use care when handling glass component(s) and/or lamp(s)
Product Usage Instructions
- Unpack all parts from cartons carefully.
- Carefully pull-out excess power cord from the lamp base while assembling to prevent the cord from becoming twisted.
- Tighten the lamp socket (A) into the MDF (B) until tight.
- Tighten the tube (C) into the MDF (B) until tight.
- Place the MDF (D) into the tube (C), then tighten the tube (E) into the tube (C) until tight.
- Place the MDF (F) into the tube (E), then tighten the tubes (G) into the tube (E) until tight.
- Place the harp (I) onto the saddle (H) of the lamp socket.
- Place the shade (J) onto the harp (I), then tighten the finial (K) into the harp (I) until tight.
- If the lamp body seems to be slanted after finished assembly, use the attached balance kits to adjust the inclination.
ASSEMBLY
- Unpack all parts from cartons carefully.
- Carefully pull-out excess power cord from the lamp base while assembling to prevent the cord from becoming twisted.
- Tighten the lamp socket(A) into the MDF(B) until tight.
- Tighten the tube(C) into the MDF(B) until tight.
- Place the MD(D) into the tube(C), then tighten the tube(E) into the tube(C) until tight.
- Place the MDF(F) into the tube(E), then tighten the tubes(G) into the tube(E) until tight.
- Place the harp(I) onto the saddle(H) of lamp socket.
- Place the shade(J)onto the harp(I),then tighten the finial(K) into the harp(I)until tight.
- Please use the attached balance kits to inclination adjustment if the lamp body seemed to be slant after finished assembly.
WIRE CONNECTION DIAGRAM
Wires meeting safety standards are required to connect the electical circuit
CAUTION: Risk of fire
Please read all instructions carefully. Before you proceed to install, make sure that the power supply is turned off and remains off until installation is completed.
PARTS INCLUDED
STEPS TO ASSEMBLE THE LAMPSHADE
- Take out the lampshade and 2 wrought iron frames.
- Unfold the fabric lampshade.
- Fix the two frames with velcro along the edge of the lampshade.
- Mount the harp and install the bulb (Not included).
- Tighten the finial to secure the lampshade.
Read User Manual Online (PDF format)
Loading......