Maxax T85-BN Lilith 28 Inch Brown-Black Table Lamp Set Instruction Manual
- October 30, 2023
- Maxax
Table of Contents
Maxax T85-BN Lilith 28 Inch Brown-Black Table Lamp Set
Product Information
Dear Customer:
Thank you for your business! If you have any questions or problems, please
send us an email to support@4modernhome.com
or call us at 870-949-8466. We will do everything possible to make you
completely satisfied with your purchase. Product reviews help future customers
to make their purchase decision. You are encouraged to share your experience
by leaving a short product review on the platform where you bought this
product. Thank you! Zgear Team
Product Usage Instructions
- Unpack all parts from cartons carefully.
- Carefully pull-out excess power cord from the lamp base while assembling to prevent the cord from becoming twisted.
- Place the harp (labeled as “D”) onto the saddle (labeled as “C”).
- Place the shade (labeled as “E”) onto the harp (labeled as “D”).
- Tighten the finial (labeled as “F”) into the harp (labeled as “D”) until tight.
Note: Ensure that the lamp is properly assembled before plugging it in and turning it on.
- Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure full compliance with N.E.C requirements If there are any questions, contact a qualified electric contractor.
- Warning: California Residents Proposition 65 This product contains lead, a chemical known to the state of California to cause cancer and birth defects or other reproductive harm. Do not place the product in your mouth. Wash your hands after handling this product.
- Caution: It is highly recommended to get an electrician to install this light. Please make sure to turn the electricity off at the main circuit breaker before beginning installation. All glass is fragile. Use care when handling glass component(s) and/or lamp(s)
PART INCLUDE
- Unpack all parts from cartons carefully.
- Carefully pull-out excess power cord from the lamp base while assembling to prevent the cord from becoming twisted.
- Place the harp(D)onto the saddle(C).
- Place the shade(E)onto the harp(D).
- Tighten the finial (F)into the harp (D)until tight.
WIRE CONNECTION DIAGRAM
Wires meeting safety standards are required to connect the electical circuit.
CAUTION: Risk of fire
Please read all instructions carefully. Before you proceed to install, make
sure that the power supply is turned off and remains off until installation is
completed.
STEPS TO ASSEMBLE THE LAMPSHADE
- Take out the lampshade and 2 wrought iron frames.
- Unfold the fabric lampshade.
- Fix the two frames with velcro along the edge of the lampshade.
- Mount the harp and install the bulb (Not included).
- Tighten the finial to secure the lampshade.