AX TECHNOLOGIES IJ305A Wireless Speaker User Manual
- June 12, 2024
- AX TECHNOLOGIES
Table of Contents
IJ305A Wireless Speaker
User Manual
Wireless Speaker
Series: IJ305A, IJ306A
FCC ID : 2AJXA-BTSPK-3
IJ305A Wireless Speaker
- Short press for the previous song; Long press to decrease the volume
- Power Switch
- Short press for the next song; Long press to increase the volume
- LED Status light
- Micro USB Charging Port
- TF Card Slot
OPERATING INSTRUCTIONS
Charging the battery
- Remove the Micro USB Port cover and insert the power cable.
- Plug the USB into a USB power source.
- When the speaker is charging, the LED indicator will turn red.
- Once the speaker is fully charged, the red LED indicator will turn off.
Wireless pairing
- Long Press the power button, the LED light will blink to indicate it is in pairing mode.
- Search the Wireless on your compatible device and select “FunAmp” to start connecting.
- Once paired, the LED indicator will remain blue and a voice prompt will indicate a successful connection.
Note: In addition to playing music, the speaker can be used to answer phone calls by pressing the Power Button.
USING YOUR SPEAKER
Long press the power button: Power On /Power Off Single press the power
button: Play/Pause Music/Answer/End call/ Capturing(Camera Mode)
Single Press the button (+): Next Song
Press and hold the button (+) : (Speaker) Volume up
Single Press the button (-): Previous Song
Press and hold the button (-) : (Speaker) Volume down
Charging
Working Time: 2-3 Hours
Charging Time: 1-2 Hours (via Micro Cable)
LED LIGHT INDICATOR
Playing Music: Slow flashing Blue LED Light
Charging via Micro Cable: Red LED Light
Device Connected: Blue LED Light On
Full Charged: No LED Light (Light Off)
SPECIFICATIONS
Product: Wireless Speaker
Wireless Version: V5.3
Working range: 10m
Impedance :4Ω
Maximum input power3W
Battery capacity300mAh
Play time2-3H
Charging time1-2H
Battery Type: 602030 Li battery
Charging Port Type: Micro
REGULATORY NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec on against harmful interference in a residen al installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep on, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or moditications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be located or
operated in conjunc on with any other antenna or transmier. The device has
been evaluated to meetgeneral RF exposure requirement. The device can be used
in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>