Oladance B2 Wearable Stereo Earbuds User Guide

Oladance B2 Wearable Stereo Earbuds

The Oladance Wearable Stereo B2 comes with a pair of earbuds, a case, and a USB Type-C cable. The red light on the charging caseflashes when charging and turns off once fully charged. The Bluetooth LED light is located in the touch control area.

Product Get Started

To get started, open the case lid. The earbuds are ready to pair when the lights on the earbuds start slow blinking.

Product Control Music

• Tap once: Play / Pause
• Tap twice: Left bud: Previous track, Right bud: Next track
• Slide Forward: Volume up
• Slide Back: Volume down

Make Phone Call

• Tap Once: Answer a call
• Tap Twice: End or decline a call
• Slide Forward: Volume up
• Slide Back: Volume down

To clear Bluetooth pairing list, tap and hold both buds at the same time for 5 seconds. To enter Bluetooth Discovery Mode, tap and hold both buds at the same time for 2 seconds.

For more customization and cool features, download the Oladance APP.

How to Wear It?

1. Pick up the earbuds.
2. Rotate along ear curve.
3. Check fit.
4. You are all set.

Product Basic Parameters

• Product name: Oladance Wearable Stereo B2
• Product model: OLA06
• Bluetooth version: 5.3
• Bluetooth protocol: HFP/A2DP/AVRCP/HSP
• Charging interface: Type-C
• Charging time: 2 hours
• Working frequency: 2400-2483.5MHz
• Rated power: 15mW

Disposal and Recycling Information

The symbol on the device, batteries, and / or the packaging indicates that the device and its electrical accessories should notbe disposed of as household garbage.

RF Exposure

The portable device is designed to meet the requirements for exposure to radio waves established by the FCC RF exposure guidelines and ISED. The highest reported Head SAR value is 0.66W/kg.

FCC ID / IC / HVIN / CMIIT ID

• FCC ID2A9AR-OLA06L
• FCC ID2A9AR-OLA06R
• IC29727-OLA06L
• IC29727-OLA06R
• HVIN:OLA06L
• HVIN:OLA06R
• CMIIT IDXXXXXXXX

Important Note: Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits. The equipment should be installed and operated with a minimum distance of 0cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Precautions

Do not listen to the voice under high sound pressure and high volume for a long time to prevent possible hearing impairment when the headset is used.

In the box

Product Introduction

Get Started

Open case lid.
Bluetooth is ready to pair when lights on earbuds start slow blinking

Control Music

Tap once:
Play / Pause

Make Phone call
Tap Once:
Answer a call

Control Music
Tap twice:
Left bud: Previous track
Right bu: Next track

Make Phone call
Tap Twice:
End or decline a call

Active voice assistant

Control Music

• Slide Forward:
  Volume up

• Slide Back:
  Volume down

Make Phone call

• Slide Forward:
  Volume up

• Slide Back:
  Volume down

Clear Bluetooth pairing list
Tap and hold both buds at the same time for 5s

Bluetooth Discovery Mode
Tap and hold 2s on both buds at the same time

You think is that all?
Download Oladance APP to enjoy more customization and cool feature.
Let’s have fun with your Oladance Wearable Stereo!

How to wear it

1. Pick up
2. Rotate along ear curve
3. Check fit
4. You are all set

Basic Parameters

• Operation temperature: 0~45°C
• Input: 5.0V 1A

Disposal and Recycling Information
This symbol (with or without a solid bar) on the device, batteries (included), and / or the packaging, indicates that the device and its electrical accessories (for example, a headset, adapter or cable) and batteries should not be disposed of as household garbage.

Battery warning
The built-in lithium battery of the product is forbidden to be disassembled, impacted, extruded or put into fire. The battery under the very low air pressure may result in explosion or flammable liquid or gas leakage. Avoid the battery in a high-temperature environment or being exposed to strong sunlight to avert explosion. Don’t use the battery continuously in case of serious ballooning. The battery shall be handled pursuant to the local regulations and shall not be disposed as household garbage. Don’t try to repair, remove or refit the battery. The explosion may happen if the battery is replaced by the one subject to incorrect model. Don’t compress or puncture the battery with hard object. The battery leakage, overheating or outbreak of a fire may occur if the battery is destroyed.

Declaration of Conformity

Hereby, Shenzhen Dancing Tech Co., Ltd., declares that this device is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.oladance.com
SAR: RF exposure information: The EIRP power of the device at maximal case is below the exempt condition, 20mW specified in EN 62479: 2010. RF exposure assessment has been performed to prove that this unit will not generate the harmful EM emission above the reference level as specified in EC Council Recommendation (1999/519/EC)..

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help important announcement.

RF Exposure
The portable device is designed to meet the requirements for exposure to radio waves established by the FCC RF exposure guidelines. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value is measured at a distance of 0mm between the radiator and the Head. The highest reported Head SAR value: 0.66W/kg.

RF Exposure
The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value is measured at a distance of 0mm between the radiator and the Head. The highest reported Head SAR value: 0.66W/kg.

• FCC ID： 2A9AR-OLA06L
• FCC ID： 2A9AR-OLA06R
• IC： 29727-OLA06L
• IC： 29727-OLA06R
• HVIN: OLA06L
• HVIN: OLA06R XXXXX
• CMIIT ID： XXXXXXXX

Important Note

Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Warning:

1. Don’t place the product into a liquid environment or avoid the product exposed to high humidity
2. Avoid extrusion to avert the damage to the product
3. Don’t attempt to dismantle the product. Put the product in a cool and dry place to keep it dry if stored for a long time
4. Avoid touching the strong magnet to prevent the magnetic headset from being demagnetized.
5. Avoid the dusty, wet and dirty environment where the electronic circuit of the equipment may be damaged if being used.
6. Don’t Use the equipment at the moment of thunderstorm because the thunderstorm may incur equipment fault or shock hazard.
7. Don’t use the equipment when riding a motorcycle or a bicycle,driving a car or crossing the road to ensure your safety.
8. Keep the equipment out of reach of children or pets to avert the damage.
9. Don’t wash the equipment with chemical cleanser or strong detergent

Don’t Listen to the voice under high sound pressure and high volume for a long time to prevent the possible hearing impairment when the headset is used.

English
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.”

References

• Oladance Official | The Worldwide Leader in the Open Wearable Audio Industry

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>